Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
Search Results "Measuring Technique"
Filters
Commonly Searched Documents
-
11B-703.5.5 Character height
-
T403 Lifts
this recommendation, the Board has determined that the public lift standards in the FMVSS provide a similar level of accessibility relative to the proposed rule, and, as well, provide measurable...
-
11B-604.3.2 Overlap
with Section 11B-606 shall be permitted on the rear wall 18 inches (457 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1676 mm) minimum measured...
-
P. MAINTENANCE OF ACCESSIBLE FEATURES AND TRAINING
The report will include the ILA certifications received pursuant to paragraphs 16 through 18 of this Consent Decree, photographs showing measurements, architectural plans, notices published...
-
Areas of Rescue Assistance [4.1.3(9), 4.3.11]
The minimum 48 inch width, measured between the leading edge of handrails, provides clearance for assisted evacuation....
-
Workshops
It describes advances in the state of the art in anthropometry, the challenges of measuring people with disabilities and recommendations made by the experts at the workshop....
-
Conclusion
Decision-makers should dialogue with the surface supplier regarding realistic, objective measurements to evaluate surface performance and maintain the surface material over the life span...
-
What barriers will it be "readily achievable" to remove?
Whether or not any of these measures is readily achievable is to be determined on a case- by-case basis in light of the particular circumstances presented and the factors discussed above...
-
Wheeled Mobility Anthropometry Project
The Access Board and the National Institute on Disability and Rehabilitation Research sponsored a Wheeled Mobility Anthropometry Project to collect measurements of approximately 500 people...
-
P. MAINTENANCE OF ACCESSIBLE FEATURES AND TRAINING
The report will include the ILA certifications received pursuant to paragraphs 16 through 18 of this Consent Decree, photographs showing measurements, architectural plans, notices published...
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
D. Technical standards for construct validity studies
A selection procedure should then be identified or developed which measures the construct identified in accord with subparagraph (2) above....
-
Section 1630.11 Administration of Tests
This provision does not apply to employment tests that require the use of sensory, manual, or speaking skills where the tests are intended to measure those skills....
-
Prevention of fraud in purchase of accessible seating. (Section-by-Section Analysis)
Such measures also must not impose burdensome requirements upon, nor restrict the rights of, individuals with disabilities....
-
11B-604.8.1.2 Doors
404 except that if the approach is from the push side of the compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured...
-
Prevention of fraud in purchase of accessible seating. (Section-by-Section Analysis)
Such measures also must not impose burdensome requirements upon, nor restrict the rights of, individuals with disabilities....
-
11B-604.8.1.2 Doors
404 except that if the approach is from the push side of the compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured...
-
Readily Achievable (Section-by-Section Analysis)
NAD also supported the NPRM proposal to consider design expertise, knowledge of specific manufacturing techniques, or the availability of certain kinds of technological solutions among a...
-
ADDENDUM TO PHASE I FINAL REPORT: Points of Clarification
Wheelchair measurements were completed without the person seated in their wheelchair. ...
-
Can People with Limited Mobility Use the Usable Circulation Path by Themselves?
Training, practice, and an understanding of the benefits and risks of each technique for a given person are important aspects of the planning process....
-
AJW Architectural Products U6104EA Unidoor Automatic Roll Towel Dispenser & Waste Receptacle Combination - Recessed
Automatic sensor will dispense a re-measured amounts of paper each time and will not dispense paper again until sensor range is cleared and allowed to reset itself....
-
The Land of Color LRV Guru™ App
LRV is a measurement that tells you how much light a color reflects and conversely how much it absorbs. LRV runs on a scale from 0% black to 100% white....
