., “rotary lift”), the requirements of this paragraph prohibiting the lift from being stowed while occupied shall not apply if the stowed position is within the passenger compartment and...
Search Results "Horizontal Position"
Commonly Searched Documents
-
§ 38.23(b)(2)(ii) Exception
-
11B-902.4 Dining surfaces and work surfaces for children’s use
surfaces that are used primarily by children 5 years and younger shall not be required to comply with Section 11B-902.4 where a clear floor or ground space complying with Section 11B-305 positioned...
-
11B-805.2.2 Beds
The clear floor space shall be positioned for parallel approach to the side of the bed....
-
11B-805.2.2 Beds
The clear floor space shall be positioned for parallel approach to the side of the bed....
-
11B-902.4 Dining surfaces and work surfaces for children’s use
surfaces that are used primarily by children 5 years and younger shall not be required to comply with Section 11B-902.4 where a clear floor or ground space complying with Section 11B-305 positioned...
-
11B-904.4.1 Parallel approach
A clear floor or ground space complying with Section 11B-305 shall be positioned for a parallel approach adjacent to the 36 inch (914 mm) minimum length of counter....
-
404.2.9 Door and Gate Opening Force
These forces do not apply to the force required to retract latch bolts or disengage other devices that hold the door or gate in a closed position....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
11B-904.4.1 Parallel approach
A clear floor or ground space complying with Section 11B-305 shall be positioned for a parallel approach adjacent to the 36 inch (914 mm) minimum length of counter....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
602.6 Water Flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
1127B.5, Item 4
each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or flared sides of the curb ramp shall not exceed one unit vertical in 12 units horizontal...
-
602.6 Water Flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
Gratings [4.5.4]
The ½ inch horizontal maximum specified for gratings is a good rule of thumb for these openings as well....
-
Handrails [4.8.5]
Handrails are required on both sides for ramps with a rise more than 6 inches or a horizontal length more than 72 inches....
-
Station 6-Speed
Design speed is critical in determining horizontal and vertical alignments. Speed is also used in calculating necessary sight distances....
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
1015.2 Where required
equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured vertically to the floor or grade below at any point within 36 inches (914 mm) horizontally...
-
1009.7.2 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
Recommendations
a minimum flat surface of 33 in. length for platforms accommodating wheeled mobility devices excluding scooters aids that can help wheelchair users mount the platform and position...
-
12113(c) Qualification standards and tests related to uncorrected vision
selection criteria based on an individual’s uncorrected vision unless the standard, test, or other selection criteria, as used by the covered entity, is shown to be job-related for the position...
-
404.2.7 Door and Gate Hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides....