[See subsections ...]
Search Results "Extended Floor Surface"
-
Basic Components for Accessible and Usable Public and Common Use Areas or Facilities
-
305.3 Size
The clear floor or ground space shall be 30 inches (760 mm) minimum by 48 inches (1220 mm) minimum. Figure 305.3 Clear Floor or Ground Space...
-
804.6.3 Dishwasher
Clear floor or ground space shall be positioned adjacent to the dishwasher door....
-
I. Introduction to the Study
In addition, the ground surface must meet the ASTM F1951‒99 Standard Specification for Determination of Accessibility of Surface Systems Under and Around Playground Equipment. ...
-
11B-604.3.1 Size
ETA Editor's Note The CBC 11B-604.3.1 requirement for maneuvering space in front of accessible water closets exceeds the 2010 ADA Standards requirement for water closet clear floor...
-
11B-604.3.1 Size
ETA Editor's Note The CBC 11B-604.3.1 requirement for maneuvering space in front of accessible water closets exceeds the 2010 ADA Standards requirement for water closet clear floor...
-
Steelcase Series 3 Height-Adjustable Work Surface with Crank
Features: Comfort + Control The simple adjustment of Series 3 allows users to position their work surfaces at the correct height for healthy, efficient computer keying, mousing and...
-
11B-703.5.6 Height from finish floor or ground
Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground....
-
Pilot Rock WPTS Square Frame Picnic Table Using Formed Steel Channel
Full length seats offer full capacity seating which is an advantage over extended top or side access tables....
-
Pilot Rock WPTS Square Frame Table Using Aluminum
Full length seats offer full capacity seating which is an advantage over extended top or side access tables....
-
Pilot Rock End Accessible Multi-Pedestal Table APT Series
These picnic tables have 8 ft. tops which extend 1 foot beyond each end of the 6 ft. seats, 30" table height and 18" seat height (nominal dimensions). ...
-
M302.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
11B-703.5.6 Height from finish floor or ground
Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground. Exceptions: 1. ...
-
M302.2.1 Adjustability (Section-by-Section Analysis)
(Significant Changes – Transfer Surface Adjustability) in the final rule the Access Board has renamed this provision and now requires the transfer surface to be adjustable to: (1) a low...
-
Mobi-mat® Recpath Demonstration Video
Mobi-Mat® RECPATH™ is a patented roll-out non-slip portable access path mat for enhancing wheelchair, strollers, bicycles, ATVs as well as any individual accessibility to...
-
Mobi-Mat® installation
Mobi-Mat® installation video
-
Bench: ADA Standard Section 612.2
Section 612.2 covers the current ADA Standards for benches in saunas and steam rooms.
-
Beneficial Designs
Beneficial Designs works towards universal access through research, design, and education. We believe all individuals should have access to the physical, intellectual, and spiritual...
-
407.2.3.1 Floor Designation
407.2.3.1 Floor Designation. Floor designations complying with 703.2 and 703.4.1 shall be provided on both jambs of elevator hoistway entrances....
-
603.2.3 Door Swing
Doors shall not swing into the clear floor space or clearance required for any fixture. Doors shall be permitted to swing into the required turning space. EXCEPTIONS: 1....
-
3.3 Guidance on the Visual Properties of Detectable Warnings
Two relatively dark surfaces may provide high luminance contrast, but on asphalt or other dark sidewalk surfaces (with reflectance less than 10 percent) high contrast is not always a good...
-
4.7.3 Slope
The slope of the clear floor or ground spaces required by section 4.0 shall not exceed 1:48 (2 percent) in any direction. Exception....
-
Test Procedures
It has been correlated to the work measurement done in ASTM F1951, Accessibility of Surface Systems, for a wide array of surfacing and floor coverings....
-
804.6.5.2 Bottom-Hinged Door Ovens
Bottom-hinged door ovens shall have the work surface required by 804.3 positioned adjacent to one side of the door....
