This attractive bracket addition to the Rakks counter bracket family is functional, stylish, easy to install and supports up to 250 lbs per pair. With its low profile design and no...
Search Results "Recreational Surfacing"
- Rakks® Aluminum Eclipse Counter Bracket
- Pilot Rock APTX Full Sized Pedestal Rectangular Utility Tables Using Recycled Plastic
- PEMKO 3" Floor Plates/Safety Treads No. 19125
- Pilot Rock WPTS Square Frame Table Using Lumber
- Emu CAMBI ADA #836 Table
- Pilot Rock PQT3-4 Square Pedestal Table Using Aluminum
- Pilot Rock UT Series Side Accessible Picnic Table Using Recycled Plastic
- KirbyBuilt Providence Walk-Thru Picnic Table
-
Camping and Picnic Facilities and Viewing Areas on Trails [F247.4]
When camping and picnic facilities or viewing areas are constructed or altered along a trail, they must comply with the applicable scoping and technical requirements for the...
-
Width of Spaces [1012.2]
Parking spaces and pull-up spaces for RVs must be at least 20 feet wide to accommodate RVs equipped with a lift (figure 27). RVs are typically 8 feet wide and require a 9-foot-wide...
-
2.6 Passing Spaces
ORARs with a clear width less than 60 inches (1525 mm) shall provide passing spaces complying with 2.6 at intervals of 200 feet (61 m) maximum. Passing spaces and resting...
-
2. Standing Supports
For horizontal standing supports, the Access Board proposed a gripping surface of 4 inches long minimum, the top of which would be required to be located 34 inches minimum and 38 inches...
- Bon® Tool Co. Aloha Slope Checker
-
Check-Out Aisles [7.3]
Writing surfaces must be 36 inches maximum from the floor....
- Angel City Sports
-
405.3 Cross Slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
405.3 Cross Slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
Poured in Place Rubber
The surface cost for PIP ranged from $6.59/sq. ft. to $19.80/sq. ft. ...
-
11B-805.7 Built-in cabinets and work surfaces
Built-in cabinets, counters and work surfaces shall be accessible, including: patient wardrobes, nurse’s stations, administrative centers, reception desks, medicine preparation areas, laboratory...
-
11B-805.7 Built-in cabinets and work surfaces
Built-in cabinets, counters and work surfaces shall be accessible, including: patient wardrobes, nurse’s stations, administrative centers, reception desks, medicine preparation areas, laboratory...
-
The Brewer Company, LLC
Company, LLC Minority Report The Brewer Company, LLC 01-Oct-2013 Final Report Medical Diagnostic Equipment Accessibility Standards Advisory Committee Section 5.1.3 Transfer Surface...
-
How to Measure Transfer Surface Height
How to Measure Transfer Surface Height Regardless of the final decision on the low height measurement, the Subcommittee agreed that the height of the transfer surface would be measured...
-
4.3.3 Slope
When the surface is not paved or is not elevated above the natural ground, slopes not steeper than 1:33 (3 percent) shall be permitted where necessary for drainage. ...