The running slope of ramps and bridgeplates used for deployment to the roadway or to curb-height boarding and alighting areas shall be 1:6 maximum, as measured to ground level with the non-rail...
Search Results "Parallel Curb Ramp"
Filters
Commonly Searched Documents
-
T402.8.1 Deployment to Roadways or to Curb Height Boarding and Alighting Areas
-
AquaTrek2 ADA Wading Pool Ramp
AquaTrek2 ADA Wading Pool Ramp The same quality ramp as our Standard AquaTrek2 products, specifically modified to meet the ADA standard for Wading Pool Access....
-
Common Use Circulation Paths in Employee Work Areas
• Handrails are not required on ramps, provided that they can be added in the future....
-
T404 Level Boarding and Alighting
[See subsections ...]
-
1022.9 Stairway identification signs
1022.9 Stairway identification signs. ... In addition to the stairway identification sign, raised characters and braille floor identification signs that comply with Chapter 11A,...
-
1023.9 Stairway identification signs
... In addition to the stairway identification sign, raised characters and braille floor identification signs that comply with Chapter 11A, Section 1143A or Chapter 11B shall be...
-
609.3 Grab Bar Vertical Clearance
-
Islands: ADA Standard Section 406.7
Section 406.7 covers the current ADA Standards for islands.
-
Attachment I
of the ramp parallel with the ground surface. ...
-
1007.2 Continuity and components
1007.2 Continuity and components. Each required accessible means of egress shall be continuous to a public way and shall consist of one or more of the following components:
-
1009.2 Continuity and components
Each required accessible means of egress shall be continuous to a public way and shall consist of one or more of the following components:
-
DSA IR 16-12: GRAB BAR DESIGN AND CONNECTIONS: 2019 CBC
Disciplines: Structural, Access History: 12/31/2019 Division of the State Architect (DSA) documents referenced within this publication are available on the DSA Publications...
-
Figure 406.3 Sides of Curb Ramps – Drawing from the U.S. Access Board
-
11B-406.5.8 Counter slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to and within 24 inches (610 mm) of the curb ramp shall not be steeper than 1:20....
-
R302.5 Grade
The grade of the pedestrian access route is measured parallel to the direction of pedestrian travel....
-
11B-406.6 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
Bradley Security Grab Bars Model SA70 Series
Requires the Premium User plan or above. (Login or upgrade your account!) -
R407.9.1 Extended Ramp Surface
R407.9.1 Extended Ramp Surface. The surface of the ramp run or landing shall extend 305 mm (1.0 ft) minimum beyond the inside face of a handrail complying with R409....
-
Interior Routes
11B-302.2 Vertical clearances/protrusions along circulation paths. 11B-307 Running and cross slopes at walking surfaces and ramps...
-
Interior Routes
11B-302.2 Vertical clearances/protrusions along circulation paths. 11B-307 Running and cross slopes at walking surfaces and ramps...
-
Regional Access & Mobilization Project (RAMP) - Rockford, Belvidere, DeKalb, Freeport, IL
Established in 1980, RAMP is a non-profit, non-residential Center for Independent Living (CIL) that emulates the Independent Living Philosophy with a mission that promotes an accessible...
-
Dimensions: ADA Standard Section 810.2.2
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
6g. Ramp Edge Protection
If the ramp or landing has a vertical drop-off on either side of the ramp, is edge protection provided? [ADA Stds 4.8.7] Yes _____ No _____...
