But I think that with the talent around this table, we can begin to frame research projects that will, in fact, support rulemaking in this area. It will be a long, hard row to hoe....
Search Results "Horizontal Projection"
Commonly Searched Documents
- 
    
  
  Rulemaking Process
  
 - Work Support of Virginia Commonwealth University
 - 
    
  
  California: Toilet Grab Bars - Uneven height allowed?
  
Commercial use (Chapter 11B) 2013 CBC construction project. ...
 - 
    
  
  4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
  
R302.7.3 Horizontal Openings. Horizontal openings in gratings and joints shall not permit passage of a sphere more than 13 mm (0.5 in) in diameter....
 - 
    
  
  M305.2.1 Location (Section-by-Section Analysis)
  
In the preamble to the MDE NPRM, the Access Board noted it was considering requiring transfer supports to be located no further than 1½ inches from the transfer surface, when measured horizontally...
 - Center for Persons with Disabilities at Utah State University
 - 
    
  
  Results comparison with current accessibility guidelines
  
The height of a horizontal grab bar (parallel to the floor) is to be between 33”-36” (83.8 and 91.4cm) for water stalls, water closets, bathtubs, and bathrooms....
 - 
    
  
  11B-221.6 Semi-ambulant seats
  
and grandstands, wheelchair spaces and companion seats are dispersed to all levels that include seating served by an accessible route; (2) Assembly areas that are required to horizontally...
 - 
    
  
  Turning Radius
  
The implications of these results on horizontal alignment are given in the "Discussion" section. Table 19....
 - 
    
  
  Best Practice Recommendations for Layout Planning
  
When possible, include both “horizontal” (side to side) and “vertical” (front to back) aisles to improve access and flow....
 - 
    
  
  11B-221.6 Semi-ambulant seats
  
and grandstands, wheelchair spaces and companion seats are dispersed to all levels that include seating served by an accessible route; (2) Assembly areas that are required to horizontally...
 - 
    
  
  11B-221.6 Semi-ambulant seats
  
arenas, and grandstands, wheelchair spaces and companion seats are dispersed to all levels that include seating served by an accessible route; 2) Assembly areas that are required to horizontally...
 - EZJamb SlideSet Modern Pocket Door Frame System
 - Norton Surface Mounted Light Duty 210 Series Door Closer
 - Blueraven Creative SensoryPEN™ for Exhibits and Audio Tours
 - NavCog Navigation iPhone App
 - Hill-Rom Golvo® 8000 / 8008 Patient Lift
 - Pacific ADA Center
 - TownSteel MS Series, Grade 1 with Push Pull Mortise Locks
 - 
    
  
  APPENDIX RESOURCES FOR LOCATING REASONABLE ACCOMMODATIONS
  
RESNA Technical Assistance Project (703) 524-6686 (Voice) (703) 524-6639 (TT) http://www.resna.org/hometa1.htm RESNA, the Rehabilitation Engineering and Assistive Technology Society...
 - 
    
  
  DSA IR 11B-7 REQUIREMENTS FOR ACCESSIBLE PARKING SPACES (with revisions issued through Jan. 2011)
  
by the Division of the State Architect (DSA) staff, and as a resource for design professionals, to promote more uniform statewide criteria for plan review and construction inspection of projects...
 - 
    
  
  11B-233.1 General
  
A private owner of housing facilities may be a beneficiary of funds from a public entity without triggering compliance with Chapter 11B when the funding is intended for projects that do...
 - 
    
  
  Market Monitoring Report
  
For example, the National Institute on Disability and Rehabilitation Research (NIDRR) funds a variety of research projects and centers, including a research center devoted to telecommunications...
 - 
    
  
  1003.3.1 Boat Slip Clearance
  
However, where mooring systems for floating piers are replaced as part of pier alteration projects, an opportunity may exist for increasing accessibility....