The design and construction of new teeing grounds or the alteration of an existing teeing area must allow golf cars to enter and exit within these limits....
Search Results "Existing Swimming Pool"
Commonly Searched Documents
-
Teeing Grounds
-
405.2 Slope
EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such slopes are necessary due...
-
3. Q: What are the basic requirements of title III?
Existing facilities are subject to the readily achievable standard for barrier removal, while newly constructed facilities and any altered portions of existing facilities must be fully accessible...
-
405.2 Slope
EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such slopes are necessary due...
-
T201 General
Two transit agencies and a bus manufacturer expressed concern about, or requested clarification of, the application of the requirements in the final rule to existing or remanufactured non-rail...
-
II. REMEDIAL ACTION
Parties agree that the technical requirements and, where appropriate, the scoping requirements of the Standards are used as a guide for determining whether a program or activity held in an existing...
-
11B-404.2.11 Vision lights
Under ADA, an existing door with a noncompliant vision light is a Safe Harbored element for path of travel and barrier removal purposes, but will have to comply when the door is replaced...
-
11B-207.1 General
Accessible means of egress are not required to be provided in existing buildings. Advisory 11B-207.1 General....
-
11B-404.2.11 Vision lights
Under ADA, an existing door with a noncompliant vision light is a Safe Harbored element for path of travel and barrier removal purposes but will have to comply when the door is replaced,...
- Whitehall Mfg. Single Temp Hemispherical Widespread Pushbutton Pneumatic Valve Conical Faucet
- Yale 7000 Series Exit Devices
- Whitehall Mfg. 3374-8IN Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 8" Centerset
- Whitehall Mfg. Single Temp Hemispherical Pushbutton Pneumatic Valve Conical Faucet 4” Centerset
- Whitehall Mfg. Hot & Cold Piezo Widespread Pushbutton Electronic Valve Conical Faucet
- Whitehall Mfg. 3373-WSF Single Temp Hemispherical Widespread Pushbutton Pneumatic Valve Conical Faucet
- Whitehall Mfg. Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 8" Centerset
- Whitehall Mfg. Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 4" Centerset
- Whitehall Mfg. Single Temp Hemispherical Pushbutton Pneumatic Valve, Conical Faucet, 8” Centerset
-
§1607.12 Retesting of applicants.
Where examinations are administered periodically with public notice, such reasonable opportunity exists, unless persons who have previously been tested are precluded from retesting....
-
§382.35(b)
Carriers may note pre-existing damage to an assistive device to the same extent that carriers do this with respect to other checked baggage....
-
§ 36.304(d)(3)(i)
(i) In addition to the provisions of section 240.2.1 of the proposed standards, where an existing play area provides elevated play components, an additional number of ground level play components...
-
2-3. Amend § 36.104
Amend § 36.104 by adding the following definitions of 1991 Standards, 2004 ADAAG, direct threat, existing facility, other power-driven mobility device, place of lodging, proposed standards...
-
§ 37.42(c)
(c) For new or altered stations serving commuter, intercity, or high-speed rail lines or systems, in which track passing through the station and adjacent to platforms is shared with existing...
-
3401.1 Scope
The provisions of this chapter shall control the alteration, repair, addition and change of occupancy of existing structures, including state-regulated structures in accordance with Sections...