Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured...
Search Results "Parking Surface"
-
1015.2 Where required
- SlabGasket Expansion Joint Replacement
-
What is an Expansion Joint Test Kit
Requires the Registered User plan or above. Login!
-
Repairing Expansion Joints - GapArmour Basics
Requires the Registered User plan or above. Login!
-
Filling expansion joints by GapArmour.com
Requires the Registered User plan or above. Login!
- National Center on Accessibility at Indiana University Bloomington
-
1012.1 General
This section contains the technical requirements for parking spaces provided within camping units and picnic units with mobility features and pull-up spaces for recreational vehicles at...
- BORA Classic Cooktop Extraction System Installation Video
-
1015.2 Where required
Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps and landings, that are located more than 30 inches (762 mm) measured...
-
1008.2.6 Ground Surfaces
1008.2.6 Ground Surfaces. Ground surfaces on accessible routes, clear floor or ground spaces, and turning spaces shall comply with 1008.2.6. Advisory 1008.2.6 Ground Surfaces....
-
3.5.2.1 Enforceable Accessible Parking Spaces
To be enforceable at accessible parking spaces, the ISA must comply with the Manual on Uniform Traffic Control Devices (MUTCD) section 2B.35, which requires the ISA to be displayed in blue...
-
11B-1005.3.2 Extended ground or deck surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
M304.2.1 Slip Resistant (Section-by-Section Analysis)
The MDE NPRM proposed to require that the standing surface on which patients stand be slip resistant....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
I. Introduction to the Study
In addition, the ground surface must meet the ASTM F1951‒99 Standard Specification for Determination of Accessibility of Surface Systems Under and Around Playground Equipment. ...
- Inpro Corporation JointMaster® DR Series Seal Expansion Joint Systems
-
1008.2.6 Ground Surfaces
Ground surfaces on accessible routes, clear floor or ground spaces, and turning spaces shall comply with 1008.2.6. Advisory 1008.2.6 Ground Surfaces....
-
11B-502.6.2 Minimum fine
Additional language or an additional sign below the International Symbol of Accessibility shall state “Minimum Fine $250.”
-
11B-502.6.2 Minimum fine
Additional language or an additional sign below the International Symbol of Accessibility shall state “Minimum Fine $250.”
-
11B-502.6.2 Minimum fine
Additional language or an additional sign below the International Symbol of Accessibility shall state “Minimum Fine $250.”
-
7.4.10.2 Outdoor Recreation Access Routes (ORARs)
At least one outdoor recreation access route complying with FSORAG section 2.0 shall connect the following places at trailheads: Accessible parking spaces or other arrival point...
- NanoPave® JSS 2-in-1 Joint Stabilizer and Sealer
-
1008.2.5.3.1 Handrail Gripping Surfaces
1008.2.5.3.1 Handrail Gripping Surfaces....
-
22. Q: How do I make my child care center's building, playground, and parking lot accessible to people with disabilities?
Q: How do I make my child care center's building, playground, and parking lot accessible to people with disabilities?...
