The call button that designates the up direction shall be located above the call button that designates the down direction. Exception: Reserved....
Search Results "Seat Location"
Commonly Searched Documents
-
11B-407.2.1.4 Location
- Access Board: Alternate Type Roll In Shower Stalls
-
T213.2 Priority Seats
Non-rail vehicles operated in fixed-route service shall designate at least two seats as priority seats for passengers with disabilities....
-
11B-411.4.8.1.2 Location
Location of indicators shall comply with Section 11B-407.4.8.1.2....
-
11B-809.10.7.2 Location
Water closets shall be located within bathrooms in a manner that permits a grab bar to be installed on at least one side of the fixture....
-
11B-407.4.6.1 Location
Controls shall be located within one of the reach ranges specified in Section 11B-308....
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
11B-407.4.8.1.2 Location
Indicators shall be located above the car control panel or above the door....
-
11B-705.1.2 Locations
Detectable warnings at the following locations shall comply with Section 11B-705.1....
-
M302.4.2 Clearance Around Base
The base of the diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of...
-
5.8.2.1 Height of Breast Platform at Time of Measurement
5.8.2.1 Height of Breast Platform at Time of Measurement Recommendation The Committee recommends measuring all knee and toe clearances when the top of the breast platform is set...
-
5.8.2.1 Height of Breast Platform At Time of Measurement
5.8.2.1 Height of Breast Platform At Time of Measurement. All knee and toe clearances should be measured when the top of the breast platform is set at 34 inches above the floor.
-
Chapter 2: Methodology
[See subsections ...]
-
M302.4.2 Clearance Around Base
The base of the equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the...
-
Re: American Standard AccessPRO Toilet
Production of the American Standard AccessPRO Toilet was discontinued, and the manufacturer says there is no replacement fixtures offered that provides ability to move laterally as...
-
Re: American Standard AccessPRO Toilet
Thanks for the heads up, Jonathan! We’ll be on the lookout for the Toto.
-
11B-411.4.6.1 Location
Controls shall be located within one of the reach ranges specified in Section 11B-308....
-
General Seating: ADA Standard Section 221.2.1.1
Section 221.2.1.1 covers scoping requirements in the current ADA Standards for general seating in assembly areas.
-
Seating Accommodations
These provisions would require carriers to make available certain seat locations to individuals with certain types of disability calling for a particular seating accommodation....
- Access Board: Standard Roll In Shower Stalls
-
5.3.1 Permitted Obstructions to Transfer Sides for M301 and M302
This would allow handholds and other features that may facilitate transfer to be located on the transfer sides....
-
A4.33.3 Placement of Wheelchair Locations
The location of wheelchair areas can be planned so that a variety of positions within the seating area are provided. This will allow choice in viewing and price categories....
-
Appendix 2- Photos of Participants in the IDEA Center Research
Appendix 2- Photos of Participants in the IDEA Center Research Examples of High Seats: Examples of Very Large and Small Clear Floor Area Widths: Examples of Very Long...
-
11B-1002.4.7.1 Shoulder-to-shoulder seating
Where an amusement ride provides shoulder-to-shoulder seating, companion seats shall be shoulder-to-shoulder with the adjacent wheelchair space....