Section 408.4.1 covers the current ADA Standards for the car dimensions and doors of limited-use/limited-application elevators.
Search Results "Exception"
Filters
Commonly Searched Documents
-
Car Dimensions and Doors: ADA Standard Section 408.4.1
-
Within a Site: ADA Standard Section 206.2.2
Section 206.2.2 covers the scoping requirements for accessible routes within a site in the most current ADA Standards.
-
Horizontal Dispersion: ADA Standard Section 221.2.3.1
Section 221.2.3.1 covers scoping requirements in the current ADA Standards for horizontal Dispersion in assembly areas.
-
Designated Aisle Seats: ADA Standard Section 221.4
Section 221.4 covers scoping requirements in the current ADA Standards for designated aisle seats in assembly areas.
-
Door and Signal Timing: ADA Standard Section 407.3.4
Section 407.3.4 covers the current ADA Standards for door and signal timing of elevator reopening devices.
-
Toe Clearance: ADA Standard Section 604.8.1.4
Section 604.8.1.4 covers the current ADA Standards for toe clearance at wheelchair accessible compartments.
-
Overlap: ADA Standard Section 604.3.2
Section 604.3.2 covers the current ADA Standards for overlapping clearances in the water closet clear floor space.
-
Grab Bars: ADA Standard Section 1009.5.7
EXCEPTION: Grab bars on transfer systems shall not be required to comply with 609.4....
-
11B-705.1.2.2.2.1 One entrance/exit point
Exceptions: 1....
-
11B-1009.5.7 Grab bars
Exception: Grab bars on transfer systems shall not be required to comply with Section 11B-609.4....
-
11B-1009.2.1 Pool lift location
Exceptions: 1. Where the entire pool depth is less than 36 inches (914 mm) or greater than 48 inches (1219 mm), compliance with Section 11B-1009.2.1 shall not be required....
-
11B-703.4.1 Height above finish floor or ground
Exception: Tactile characters for elevator car controls shall not be required to comply with Section 11B-703.4.1....
-
11B-307.2 Protrusion limits
Exception: Handrails shall be permitted to protrude 4½ inches (114 mm) maximum. Advisory 11B-307.2 Protrusion limits....
-
11B-407.3.4 Door and signal timing
Exceptions: For cars with in-car lanterns, T shall be permitted to begin when the signal is visible from the point 60 inches (1524 mm) directly in front of the farthest hall call button...
-
11B-404.3.2 Maneuvering clearance
Exception: Where automatic doors and gates remain open in the power-off condition, compliance with Section 11B-404.2.4 shall not be required....
-
11B-411.2.2.1 Visible identification
Exception: Existing buildings shall be permitted to have a visible identification fixture with a car designation character adjacent to each elevator car entrance centered at 72 inches (1829...
-
11B-705.1.1.2 Dome spacing
Exception: Where installed in a radial pattern, truncated domes shall have a center-to-center spacing of 1.6 inches (41 mm) minimum to 2.4 inches (61 mm) maximum....
-
1009.6.3 Size
Exception: The enforcing agency may reduce the size of each required area of refuge to accommodate one wheelchair space that is not less than 30 inches by 48 inches (762 mm by 1219 mm) on...
-
11B-205.1 General
Exceptions: 1. Operable parts that are intended for use only by service or maintenance personnel shall not be required to comply with Section 11B-309. 2. ...
-
11B-221.2.3.2 Vertical dispersion
Exceptions: 1. ...
-
M301.4 Lift Compatibility (Section-by-Section Analysis)
Additionally, question 27 in the MDE NPRM preamble requested input on whether the final rule should provide an exception from the lift compatibility requirements where the diagnostic equipment...
-
F232.2 General Holding Cells and General Housing Cells
EXCEPTION: Alterations to cells shall not be required to comply except to the extent determined by regulations issued by the appropriate Federal agency having authority under Section 504...
-
206.2.8 Employee Work Areas
EXCEPTIONS: 1....
-
206.2.8 Employee Work Areas
EXCEPTIONS: 1....