Access aisles at vehicle spaces shall not overlap the vehicular way and may be placed on either side of the vehicle space they serve except for van accessible spaces which shall have...
Search Results "Electrical Receptacle"
Commonly Searched Documents
-
11B-812.7.1 Location
-
11B-812.5.4 Arrangement
Vehicle spaces and access aisles shall be designed so that persons using them are not required to travel behind vehicle spaces or parking spaces other than the vehicle space in which...
-
11B-812.8.5 Drive-up
Drive-up EVCS shall not be required to be identified by an ISA.
-
11B-812.10.4 Location
EV chargers shall be adjacent to, and within the projected width of, the vehicle space being served. Exceptions: EV chargers serving more than one EVCS shall be adjacent to,...
-
Has there been consideration for electric vehicles being parked in valet mode that could share EVSE and meet the equivalent EVSE option? This could reduce the cost of construction and major electrical upgrades.
RESPONSE: Electric vehicles may be parked by a valet just as any other car....
-
9.3.1 General
Permanently installed telephones shall have volume controls complying with 4.31.5; an accessible electrical outlet within 4 ft (1220 mm) of a telephone connection shall be provided to facilitate...
- Wallhub Keeper Rocker Light Switch Cover
-
DRIVE-UP ELECTRIC VEHICLE CHARGING STATION
An electric vehicle charging station in which use is limited to 30 minutes maximum and is provided at a location where the electric vehicle approaches in the forward direction, stops in...
-
DRIVE-UP ELECTRIC VEHICLE CHARGING STATION
An electric vehicle charging station in which use is limited to 30 minutes maximum and is provided at a location where the electric vehicle approaches in the forward direction, stops in...
-
Drive-up electric vehicle charging station
DEFINITION NOTES Drive-up electric vehicle charging station New definition for electric vehicle charging station that functions...
-
11B-228 Depositories, vending machines, change machines, mail boxes, fuel dispensers, and electric vehicle charging stations
SECTION TITLE NOTES 11B-228 Depositories, vending machines, change machines, mail boxes, fuel dispensers, and electric...
-
Can a single EV charger service two EV Accessible spots or does each spot have to have its own charger?
(see CBC Chapter 2 definition of “Electric Vehicle Charging Station”)...
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum. The centerline of the text shall be a maximum of 6 inches...
-
11B-233.3.1.2.6 Public housing facility site impracticality
ETA Editor's Note This section of the 2019 California Building Code was amended by the Division of the State Architect. The requirements in this section were previously found in...
-
11B-812.5.5 Obstructions
EVCS shall be designed so accessible routes are not obstructed by cables or other elements.
-
11B-203.9 Employee workstations
Exception: Receptacles, controls, and switches that are an integral part of workstation furnishings, fixtures, and equipment shall not be required to comply with 11B-308.1.1 and 11B-308.1.2...
-
§100.205(d)
(d) The application of paragraph (c) of this section may be illustrated by the following examples: Example (1): A developer plans to construct a 100 unit condominium apartment...
-
11B-228.3 Electric vehicle charging stations
[See subsections ...]
-
11B-228.3 Electric vehicle charging stations
[See subsections ...]
-
EVSE Payment Kiosk
Requires the Registered User plan or above. Login!
-
11B-812.5.2 Accessible route to EV charger
An accessible route complying with Section 11B-402 shall be provided between the vehicle space and the EV charger which serves it.
-
11B-812.8.7 Location
Required identification signs shall be visible from the EVCS it serves. Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected...
-
11B-812.8.4 Ambulatory
Ambulatory EVCS shall not be required to be identified by an ISA.
-
11B-812.8.6 Finish and size
Identification signs shall be reflectorized with a minimum area of 70 square inches (45161 mm2).