In transfer type shower compartments, thresholds 1/2 inch (13 mm) high maximum shall be beveled, rounded, or vertical....
Search Results "Side Transfer Surface"
Commonly Searched Documents
-
608.7 Thresholds
-
1009.4.1 Clear Deck Space
A clear deck space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer wall....
-
11B-813.2.1.2 Clearance
A 36 inches minimum (914 mm) width side clearance shall be provided along the entire length of one side of adult changing tables....
-
Development of Surface Roughness Standards for Pathways Used by Wheelchair Users: Final Report
Development of Surface Roughness Standards for Pathways Used by Wheelchair Users: Final Report December 2014 Human Engineering Research Laboratories VA Pittsburgh Healthcare System...
-
11B-902.4.2 Height
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (762 mm) maximum above the finish floor or ground.
-
Mirror Height
The guidelines specify that accessible mirrors be mounted so that the bottom edge of the reflecting surface is no higher than 40 inches (603.3)....
-
National Trail Surfaces Study Final Report
National Trail Surface Study Final Report February 2014 Staff Liaison Bill Botten U.S....
-
11B-606.5 Exposed pipes and surfaces
There shall be no sharp or abrasive surfaces under lavatories and sinks....
-
11B-606.5 Exposed pipes and surfaces
There shall be no sharp or abrasive surfaces under lavatories and sinks....
-
Participants
Further demographic details of the study can be seen in Table 3, including hours using a wheelchair per day, years using a wheelchair, number of level and non-level transfers and average...
-
Material Characteristics (slide 6)
Matte finishes (slide 6) are always better than specular surfaces or polished granite. And that can be columns, and it can even be lighting fixtures....
-
604.5 Grab Bars
Grab bars shall be provided on the side wall closest to the water closet and on the rear wall. Advisory 604.5 Grab Bars Exception 2....
- Access-Able Designs Wall Mounted Shower Transfer Bench SH-400
-
11B-804.3 Kitchen work surface
In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...
-
11B-804.3 Kitchen work surface
In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...
-
1016.2 Surface
The surface of outdoor recreation access routes, passing spaces, and resting intervals shall be firm and stable....
-
1016.2 Surface
The surface of outdoor recreation access routes, passing spaces, and resting intervals shall be firm and stable....
-
1016.2 Surface
This section requires the surface of outdoor recreation access routes, passing spaces, and resting intervals to be firm and stable....
-
T302.1 General
Walking surfaces in non-rail vehicles shall comply with T302. EXCEPTION: Walking surfaces on lifts shall not be required to comply with T302....
-
R304.5.1.2 Shared Use Paths
As proposed in the NPRM, R304.5.1 would require the clear width of curb ramp runs (excluding flared sides), blended transitions, and turning spaces to be 4 feet minimum....
- Tile Tech Pavers® Traver-Pave™
- U.S. Tape Company, Inc. Digi-Pro
-
3. Review the Research Findings About Accessibility Issues for Play Surfaces
study on the accessibility of playground surfaces....
-
5.5.1 Armrest Provision for M302
If provided, armrests cannot interfere with transfer supports during the transfer....