(2) Ramp surface....
Search Results "Kitchen Work Surface"
-
§ 38.83(c)(2) Ramp surface
-
5.2.3 Transfer Surface Measurement
5.2.3 Transfer Surface Measurement. The transfer surface should be measured from the center-point of each side of the transfer surface....
-
§ 38.125(c)(2) Ramp surface
(2) Ramp surface....
-
Visible Alarms
These commenters also raised concerns that all employee work areas within existing buildings and facilities must be equipped with accessibility features....
-
1005.3.2 Extended Ground or Deck Surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
1.2.2
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
-
Storage: ADA Standard Section 225
Section 225 covers scoping requirements in the current ADA Standards for storage.
-
11B-225 Storage
[See subsections ...]
-
11B-225 Storage
[See subsections ...]
-
5.2.2.1 Transfer Surface Width Recommendations for M302
5.2.2.1 Transfer Surface Width Recommendations for M302 The Committee recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily...
-
Executive Summary
After traveling over each surface, subjects were asked to subjectively rate each surface and decide whether the surface was acceptable or not....
-
502.4 Floor or Ground Surfaces
502.4 Floor or Ground Surfaces. Parking spaces and access aisles serving them shall comply with 302. Access aisles shall be at the same level as the parking spaces they serve....
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
-
Question 2
Are the surfaces of all elements of the parking area and accessible route smooth and free of large cracks and broken or raised areas?...
-
Tiles
TIL was the most expensive of the five types of surfaces identified for study. ...
- Ytterberg Scientific Inc. FloorPro® Floor Flatness Measurement Device
-
Q10: Two or More 'Maintenance' Treatments
Filling and Sealing, Diamond Grinding, Dowel Bar Retrofit, Fog Seals, Joint Crack Seals, Joint Repairs, Pavement Patching, Scrub Sealing, Slurry Seals, Spot High-Friction Treatments, and Surface...
- Landscape Forms GO Outdoor Table
-
Q2: Milling a Road Surface
Q2: The Joint Technical Assistance states that “[r]esurfacing is an alteration that triggers the requirement to add curb ramps if it involves work on a street or roadway spanning from one...
-
9.1 Overview of Legal Obligations
9.1 Overview of Legal Obligations An employer may not inquire into an applicant's workers' compensation history before making a conditional offer of...
-
1005.3.2 Extended Ground or Deck Surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
Improved Engineered Wood Fiber (EWF) Surfaces for Accessible Playgrounds Field Performance Testing: Final Report II
Improved Engineered Wood Fiber (EWF) Surfaces for Accessible Playgrounds Field Performance Testing: Final Report II Field Performance Testing March, 2002 – January, 2003 USDA...
- SlabGasket™ Expansion Joint Replacement Solution