The Global Alliance on Accessible Technologies and Environments (GAATES) is the leading international organization dedicated to the promotion of accessibility of the built and virtual environments...
Search Results "IBC: International Building Code"
Filters
Commonly Searched Documents
-
Global Alliance on Accessible Technologies and Environments (GAATES)
-
GRADE (Adjacent Ground Elevation)
[DSA-AC & HCD 1-AC] The lowest point of elevation of the finished surface of the ground, paving or sidewalk within the area between the building and the property line or, when the property...
-
Section 35.151(c) Accessibility standards for new construction and alterations
that form the basis of many State and local building code requirements....
-
Section 35.151(c) Accessibility standards for new construction and alterations (Section-by-Section Analysis)
that form the basis of many State and local building code requirements....
-
Sec.36.607(a)(2)
(2) For example, if certain equipment is not covered by the code, the determination of equivalency cannot be used as evidence with respect to the question of whether equipment in a building...
-
4.1.7(2)(a) Alterations to Qualified Historic Buildings and Facilities Subject to Section 106 of the National Historic Preservation Act
(a) Alterations to Qualified Historic Buildings and Facilities Subject to Section 106 of the National Historic Preservation Act:...
-
11.3 Q. The site analysis test calls for a calculation of the percentage of the buildable areas having slopes of less than 10 percent. What is the definition of buildable areas?
The buildable area is any area of the lot or site where a building can be located in compliance with applicable codes and zoning regulations....
-
TownSteel Resetting factory mode for XCE XME 2000 series
One method with the master code and the other without the master code...
-
11B-504.5 Nosings
Exception: In existing buildings there is no requirement to retroactively alter existing nosing projections of 1½ inches (38 mm) which were constructed in compliance with the building code...
-
2. REGULATORY BUILT-IN TOLERANCES
REGULATORY BUILT-IN TOLERANCES: California Building Code Section 1101B.5 indicates all dimensions are subject to conventional industry tolerances except where the requirement is stated as...
-
General: ADA Standard Section 210.1
Section 210.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for stairways.
-
General: ADA Standard Section 407.1
Section 407.1 of the ADA Standards covers information in the current ADA Standards for elevators.
-
§ 36.606(a)(2)
(2) For example, if certain equipment is not covered by the code, the determination of equivalency cannot be used as evidence with respect to the question of whether equipment in a building...
-
11B-302.2 Carpet
The accessibility provisions of the California Building Code apply only to the design, alteration, and new construction of buildings and facilities, not to movable floor mats....
-
ETA Opinion: ADA Signage at Exit Doors
ETA Opinion: ADA Signage at Exit Doors Notes from written and oral communication with the DOJ and references to the International Building Code and the Access Board The Department...
-
Current Accessibility Guidelines That Apply to the Forest Service
Forest Service drinking fountains, toilet facilities, parking lots and spaces, cabins, and administrative buildings are among the components covered by ABAAS....
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due to additions...
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due to additions...
-
11B-106.5 Defined terms
Non-italicized terms indicate 2010 Americans with Disabilities Act Standards model code definitions....
-
ACCESSIBLE
[DSA-AC & HCD 1-AC] A site, building, facility, or portion thereof that is approachable and usable by persons with disabilities in compliance with this code....
-
ACCESSIBLE
[DSA-AC & HCD 1-AC] A site, building, facility, or portion thereof that is approachable and usable by persons with disabilities in compliance with this code....
-
[A] 104.11 Alternative materials, design and methods of construction and equipment
The provisions of this code are not intended to prevent the installation of any material or to prohibit any design or method of construction not specifically prescribed by this code, provided...
-
General description of monetized benefits for water closet clearance in single-user toilet rooms—out-swinging doors (Req. #28)
to have single-user toilet rooms with out-swinging doors already are covered by State or local building codes that require equivalent water closet clearances....
-
General description of monetized benefits for water closet clearance in single-user toilet rooms—out-swinging doors (Req. # 28)
to have single-user toilet rooms with out-swinging doors already are covered by State or local building codes that require equivalent water closet clearances....
