(d) Doors. (i) Where existing elements prohibit strict compliance with the clearance requirements of 4.13.5, a projection of 5/8 in (16 mm) maximum will be permitted for the latch...
Search Results "Clear Opening"
Filters
Commonly Searched Documents
-
4.1.6(4)(d)
-
§100.205(c)(2)
(2) All the doors designed to allow passage into and within all premises are sufficiently wide to allow passage by handicapped persons in wheelchairs; and
-
4.23.2 DOORS
Doors to accessible bathrooms shall comply with 4.13. Doors shall not swing into the floor space required for any fixture.
-
11B-604.9.2 Clearance
11B-604.9.2 Clearance. Clearance around a water closet shall comply with Section 11B-604.3.
-
11B-1009.2.2 Seat location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (406 mm) minimum from the edge of the pool. The deck surface between the centerline of...
-
§ 38.153(c)
(c)
-
A. Door Width
A. Door Width. Achieving a 30 inch wide front door on an over-the-road bus is considered not feasible if doing so would necessitate reduction of the bus approach angle, relocating...
-
§ 38.113(b) Passageway
(b) Passageway. Doorways required to be accessible by paragraph (a) of this section shall permit access by persons using mobility aids and shall have an unobstructed passageway at...
-
11B-1009.2.2 Seat location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (406 mm) minimum from the edge of the pool. The deck surface between the centerline of...
-
11B-604.9.2 Clearance
Clearance around a water closet shall comply with Section 11B-604.3.
-
7.4.5 Passing Spaces
Trails with a clear tread width less than 60 inches (1525 mm) shall provide passing spaces complying with 7.4.5 at intervals of 1000 feet (300 m) maximum. ...
-
Just Manufacturing Stainless Steel Cup Strainer ADA Compliant Drain System
Body of stainless steel. Strainer of stainless steel. Stopper of rubber. 17 gauge chrome plated brass tailpiece. Die-cast zinc lock...
-
McGuire Manufacturing Co., Inc. 1151AWC: Offset with 151 Stainless Steel Basket Strainer
Offset sink strainer with stainless steel basket strainer with stainless steel basket. 2 3/4" x 4 3/8" OD.
-
McGuire Manufacturing Co., Inc. 155LATWC: Offset Lift and Turn PO Plug
Wheelchair lavatory strainer. Furnished with heavy brass elbow and 17GA seamless brass offset tailpiece. 8 3/4" x 5 1/8" OD.
-
Accessible Sidewalks 2: Pedestrians with Ambulatory Impairments
Requires the Registered User plan or above. Login! -
5.1.7 Surface
The surface of the clear ground space shall be firm and stable....
-
Figure 406.4 Landings at the Top of Curb Ramps – Drawing from the U.S. Access Board
-
11B-809.10.4 Sufficient maneuvering space
Where doors swing into the toilet and bathing or powder rooms required to comply with Section 11B-809.10, a clear maneuvering space of 30 (762 mm) inches by 48 inches (1219 mm) minimum shall...
-
4.34.5.1 DOORS
Doors shall not swing into the clear floor space required for any fixture....
-
Fixtures
Fixtures TAS 604.3.2 also allows the clear floor space and clearances required at other “fixtures” to overlap the water closet clearance....
-
Entrances
All door openings must provide a minimum width of 32 inches and there must also be enough room for a person using a wheelchair to maneuver to open the door, including 18 inches of clear...
-
11B-805.2.2 Beds
A 36 inch (914 mm) minimum wide clear space shall be provided along the full length of each side of the beds. [2010 ADAS] 805.3 Clear Floor or Ground Space. ...
-
11B-805.2.2 Beds
A 36 inch (914 mm) minimum wide clear space shall be provided along the full length of each side of the beds. [2010 ADAS] 805.3 Clear Floor or Ground Space....
-
11B-805.2.2 Beds
A 36 inch (914 mm) minimum wide clear space shall be provided along the full length of each side of the beds. [2010 ADA Standards] 805.3 Clear Floor or Ground Space....
