Includes self-closing, light touch front and side pushbar actuation with raised letters for the visually impaired....
Search Results "Push Side"
Commonly Searched Documents
- Halsey Taylor Bi-Level HAC Green Cooler with Hydroboost® Bottle Filler
-
R409.2 Where Required
Handrails shall be provided on both sides of ramps and stairways....
-
Top Landings
Otherwise, maneuvering at the top of ramps would require turning on the flared sides. Landings must also be as wide as the curb ramp they serve....
-
604.8.1.4 Toe Clearance
The front partition and at least one side partition shall provide a toe clearance of 9 inches (230 mm) minimum above the finish floor and 6 inches (150 mm) deep minimum beyond the compartment-side...
-
604.8.1.4 Toe Clearance
The front partition and at least one side partition shall provide a toe clearance of 9 inches (230 mm) minimum above the finish floor and 6 inches (150 mm) deep minimum beyond the compartment-side...
-
T207 Circulation Paths
As a matter of clarification, the proposed rule specified that, where doorways are provided on one side of a non-rail vehicle, an accessible circulation path must connect each wheelchair...
-
11B-705.1.2.3 Islands or cut-through medians
pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum on each side...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
Toilet Room Doors
Other commenters asserted that public single-user toilet rooms always include a closer and a latch on the entry door, requiring a larger clear floor space than shown on the push side of...
-
1134A.5 Bathtubs
There shall be a minimum clear floor space 48 inches parallel by 30 inches perpendicular (1219 mm by 762 mm) to the side of a bathtub or bathtub-shower combination to provide for the maneuvering...
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
- Norton 5600 Series Low Energy Operator
- Triumph Foundation
-
Imaging bed
A component of diagnostic scanning equipment that accommodates patients in supine, prone, or side-lying positions....
-
M18
Is the flush valve located on the side adjacent to the lavatory? [ADA Standards § 4.16.5] Yes No...
-
4.7.3 Width
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
4.7.3 WIDTH
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
M304.3 Standing Supports
Standing supports shall be provided on each side of the standing surface and shall comply with M305.3....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm) minimum...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
1. Location
Curb ramps must be placed to enable a person with a mobility disability to travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
406.4 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...