Using the Tape Measure A metal tape measure is needed to measure the length, width, height, and depth of various elements....
Search Results "Continuous Width"
Commonly Searched Documents
-
2. Using the Tape Measure
-
[A] PUBLIC WAY
other parcel of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width...
-
PUBLIC WAY
other parcel of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width...
-
11B-407.4.1 Car dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Table 11B-407.4.1....
-
DESIGNATED PUBLIC TRANSPORTATION
than transportation by aircraft or intercity or commuter rail transportation) that provides the general public with general or special service, including charter service, on a regular and continuing...
-
12209(b)(2)(B)(II)
.-- The resolution referred to in clause (i) is House Resolution 15 of the One Hundred First Congress, as agreed to January 3, 1989, or any other povision that continues in effect the provisions...
-
R215 Passenger Loading Zones (Section-by-Section Analysis)
R215 Passenger Loading Zones (Section-by-Section Analysis) Where passenger loading zones are provided, at least one passenger loading zone for each 30 meters (100 feet) of continuous...
-
225(f)(4) Suspension or revocation of certification
In a State whose program has been suspended or revoked, the Commission shall take such steps as may be necessary, consistent with this section, to ensure continuity of telecommunications...
-
11B-505.10.1 Top and bottom extension at ramps
Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent ramp run....
- Bobrick SureFlo® Automatic, Top Fill Bulk Foam Soap Dispenser B-828
- Bobrick SureFlo® Automatic Soap Dispenser B-824
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
1017.5 Tread Obstacles
The frequency of tread obstacles and tread obstacles that cross the full width of the trail tread can make travel difficult for individuals who use wheeled mobility devices....
-
11B-705.2 Detectable directional texture
The width of the directional texture shall be equal to the width of the transit vehicle’s door opening. The depth of the texture shall not be less than 36 inches (914 mm)....
-
607.5 Controls
Controls shall be between the bathtub rim and grab bar, and between the open side of the bathtub and the centerline of the width of the bathtub....
-
404.2.6 Doors in Series and Gates in Series
The distance between two hinged or pivoted doors in series and gates in series shall be 48 inches (1220 mm) minimum plus the width of doors or gates swinging into the space....
-
11B-1009.5.1 Transfer platform
Transfer platforms shall provide 19 inches (483 mm) minimum clear depth and 24 inches (610 mm) minimum clear width. FIGURE 11B-1009.5.1 SIZE OF TRANSFER PLATFORM...
-
R304.5.5 Clear Space
Beyond the bottom grade break, a clear space 1.2 m (4.0 ft) minimum by 1.2 m (4.0 ft) minimum shall be provided within the width of the pedestrian street crossing and wholly outside the...
-
2. b. i. Clear door openings
Clear door openings: Door openings should provide a clear width of 32 inches (815 mm) minimum....
-
§ 37.131(a)(1)(i)
(i) The entity shall provide complementary paratransit service to origins and destinations within corridors with a width of three-fourths of a mile on each side of each fixed route....
- Magnuson Group VOICI Magazine Racks
-
§382.133(e)
process as indicated in paragraphs (e)(1) through (6) of this section upon inquiry from an individual concerning the use in the cabin during air transportation of a ventilator, respirator, continuous...
-
505.10.3 Bottom Extension at Stairs
Extension shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
T402.7 Edge Guards
Ramps and bridgeplates shall provide edge guards continuously along each side of the ramp or bridgeplate to within 3 inches (75 mm) of the end of the ramp or bridgeplate that is deployed...