Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
Search Results "Military Installation"
-
308.3.2 Obstructed High Reach
-
4.1.2(18)
For assembly areas without amplification systems and for spaces used primarily as meeting and conference rooms, a permanently installed or portable listening system shall be provided....
-
Employee Work Areas [§206.2.8]
This applies to the size of work areas as defined by permanently installed walls, partitions, counters, casework, or furnishings, but not modular partitions or furnishings, including systems...
-
Signage
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
11B-704.4.1 Height
A telephone with a TTY installed underneath cannot also be a wheelchair accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-704.4.1 Height
A telephone with a TTY installed underneath cannot also be a wheelchair accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Existing parallel curb ramps with detectable warnings in compliance with the code requirements in effect at the time of installation shall not be required to provide a minimum 36 inches...
-
General Substantive Requirements of the New Construction Provisions (Preamble, Section-by-Section Analysis)
no control over access at the point where streets, curbs, or sidewalks already exist, and in those instances the entity is encouraged to request modifications to a sidewalk, including installation...
-
Platform Lifts
Section 206.7 specifies where platform lifts can be installed....
-
Soiltac Liquid Mix-In
Soiltac Liquid Mix-In more than one year after installation seemed to maintain itself. June 12, 2008. Soiltac Liquid Mix-In almost two years after installation. ...
-
General Substantive Requirements of the New Construction Provisions (Section-By-Section Analysis and Response to Comments)
no control over access at the point where streets, curbs, or sidewalks already exist, and in those instances the entity is encouraged to request modifications to a sidewalk, including installation...
-
Accessible Entrance
If a drop-off exists, then a barrier such as a raised edge or railing must be installed....
-
About This Tool Kit
The Tool Kit will be released in installments to help state and local officials begin to set up an “accessibility audit.”...
-
308 Reach Ranges
The gas pump manufacturers impressed upon the Board the great difficulty of installing a redesigned gas pump on an existing curb....
-
Program Accessibility
The town council considers installing an elevator, but determines it’s too costly....
-
New Accessible Handpump for Campgrounds
Figure 1—The first Forest Service accessible handpump was installed on the Lolo National Forest in the fall of 2002. ...
-
Accessibility - Flatness and Lippage
Accessibility - Flatness and Lippage: With regard to flatness, the amount of substrate variation generally is reflected in the finished tile installation....
-
Accessible Mats for Beach and Outdoor Events
Their accessible mats are easy to install, clean, transport, and store. You can leave them out for the whole season or use them for just a few hours....
-
11B-809.10.2 Number of complying bathing rooms and fixtures
Where two or more bathrooms are provided, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.10.5 and a shower compartment is provided in a subsequent bathroom...
-
11B-809.8.3.1 Floor or ground surface
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25 mm), provided a ramp with a maximum slope of 1:8 is permanently installed as...
-
11B-809.10.2 Number of complying bathrooms and fixtures
Where two or more bathrooms are provided, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.10.5 and a shower compartment is provided in a subsequent bathroom...
-
ASME
ASME A17.1 is used by local jurisdictions throughout the United States for the design, construction, installation, operation, inspection, testing, maintenance, alteration, and repair of...
