Many commenters recommended that all full bathrooms be made accessible. Other commenters recommended that only one full bathroom be required to be made accessible....
Search Results "Full Length Mirror"
-
Number of Accessible Bathrooms
-
Documenting Exceptions
Documentation of the basis for exceptions is required only when a condition for an exception prohibits full compliance with technical requirements on a portion of a trail or beach access...
-
General [4.1.6(1)]
Compliance can be followed on an element-by-element basis, except where the work amounts to full alteration of a room or space, in which case the room or space must be made fully accessible...
-
Other Road and Shared Use Path Users
A full evaluation of these devices and vehicles as part of this study was either not possible or unnecessary for one of the following reasons: They are used very infrequently so...
-
RECITALS
general public, against Kaiser, in the Superior Court for the State of California, Alameda County, Case No. 829265-2, alleging that Kaiser fails to provide people with mobility disabilities full...
-
American Standard Acrylic Shroud for American Standard Selectronic Faucets
On toilets the super smooth mirror like EverClean™ surface is easier to keep clean, even after years of use. That means you spend less time cleaning and more time enjoying....
-
Allegion XceedID® PR10 Proximity Mini-Mullion Reader
Its small, but attractive design mirrors the styling of the aptiQ™ Multi-Technology Reader line-up, and is available in a variety of color options....
-
Picnic Tables
The number of wheelchair seating spaces that must be provided at each table is based on the length of the picnic table (figure 78). Always ensure at least one wheelchair seating space....
-
11B-1003.2.2 Boarding piers at boat launch ramps
Where the total length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section...
-
1008.2.4.1 Ground Level
shall be permitted to be 44 inches (1120 mm) minimum, if at least one turning space complying with 304.3 is provided where the restricted accessible route exceeds 30 feet (9145 mm) in length...
-
1002.4.4.2 Side Entry
For example, where a 42 inch (1065 mm) opening is provided, a minimum clear space of 60 inches (1525 mm) in length and 36 inches (915mm) in depth is needed to ensure adequate space for maneuvering...
-
1008.2.4.1 Ground Level
shall be permitted to be 44 inches (1120 mm) minimum, if at least one turning space complying with 304.3 is provided where the restricted accessible route exceeds 30 feet (9145 mm) in length...
-
11B-1002.4.4.2 Side entry
For example, where a 42 inch (1065 mm) opening is provided, a minimum clear space of 60 inches (1525 mm) in length and 36 inches (915mm) in depth is needed to ensure adequate space for maneuvering...
-
Submerged Depth
Landings must be a minimum of 36 inches in width and 60 inches in length. The sloped entry may be a maximum of 30 feet at 1:12 (8.33%) slope before an intermediate landing is required....
-
604.5.2 Rear Wall
The rear grab bar shall be permitted to be 24 inches (610 mm) long minimum, centered on the water closet, where wall space does not permit a length of 36 inches (915 mm) minimum due to the...
-
1002.4.4.2 Side Entry
For example, where a 42 inch (1065 mm) opening is provided, a minimum clear space of 60 inches (1525 mm) in length and 36 inches (915mm) in depth is needed to ensure adequate space for maneuvering...
-
1008.2.4.1 Ground Level
shall be permitted to be 44 inches (1120 mm) minimum, if at least one turning space complying with 304.3 is provided where the restricted accessible route exceeds 30 feet (9145 mm) in length...
-
T302.3 Openings
Ramp and bridgeplate surfaces shall be permitted to have one opening 1½ inches (38 mm) maximum in width and 4½ inches (115 mm) maximum in length to allow the operator to grasp the ramp or...
-
1002.4.4.2 Side Entry
For example, where a 42 inch (1065 mm) opening is provided, a minimum clear space of 60 inches (1525 mm) in length and 36 inches (915mm) in depth is needed to ensure adequate space for maneuvering...
-
11B-411.2.3.1 Floor designation signs
The outside diameter of the star shall be 2 inches (51 mm) and all points shall be of equal length. Raised characters, including the star, shall be white on a black background....
-
406.7 Islands
Each 48 inch (1220 mm) minimum by 36 inch (915 mm) minimum area shall be oriented so that the 48 inch (1220 mm) minimum length is in the direction of the running slope of the curb ramp it...
-
11B-1008.2.4.1 Ground level
permitted to be 44 inches (1118 mm) minimum, if at least one turning space complying with Section 11B-304.3 is provided where the restricted accessible route exceeds 30 feet (9144 mm) in length...
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...
-
604.5.2 Rear Wall
The rear grab bar shall be permitted to be 24 inches (610 mm) long minimum, centered on the water closet, where wall space does not permit a length of 36 inches (915 mm) minimum due to the...
