Have local authorities accepted one-piece dispensers in toilet compartments that are recessed behind the horizontal grab bars? These units stick out ¼" or so....
Search Results "Compartment Depth"
Commonly Searched Documents
-
Grab bar clearance
-
Table of Contents
504 Stairways 505 Handrails CHAPTER 6: PLUMBING ELEMENTS AND FACILITIES 601 General 602 Drinking Fountains 603 Toilet and Bathing Rooms 604 Water Closets and Toilet Compartments...
- Bobrick ConturaSeries Recessed Sanitary Napkin Disposal B-4353
- Tork Toilet Seat Cover Dispenser White
- Bobrick Countertop-Mounted Circular Waste Chute B-529
- Assisted Living Directory
-
Bathroom
In response to the concern of several commenters, the Department has revised the definition of "bathroom" in the final Guidelines to clarify that a bathroom includes a "compartmented" bathroom...
-
Shower Threshold
However, the Board has revised the specification to allow thresholds at transfer compartments to be vertical or rounded instead of beveled....
-
Technical Memorandum TM 2013-19 Private Toilet and Bathing Rooms
Shower Compartments 608.3, Exception 1: Grab Bars. This clarification does not constitute a substantive change to the compliance requirements of TAS 213.2 and 213.3....
-
2. Equipment Clearances for Breast Platforms
The proposed rule included a requirement that 17 inches minimum and 25 inches maximum of the 48-inch wheelchair space depth include knee and toe clearance....
- Bobrick TrimLineSeries Recessed Sanitary Napkins Disposal B-35303
-
Soiltac Liquid Topical
The stabilizer has a penetration depth of 1/8 inch. The first noticeable signs of change for this surface came after the first heavy rainfall at the March 2008 testing....
-
809.2.2 Turning Space
EXCEPTION: Turning space shall not be required in exterior spaces 30 inches (760 mm) maximum in depth or width. Advisory 809.2.2 Turning Space....
-
11B-705.2 Detectable directional texture
The depth of the texture shall not be less than 36 inches (914 mm). FIGURE 11B-705.2 ‡‡ DETECTABLE DIRECTIONAL TEXTURE...
-
M303.2.2 Width (Section-by-Section Analysis)
(Significant Changes – Width and Depth of Wheelchair Spaces), and discussed briefly below....
-
Section 5 References
“Revised Knee Clearance Depth and Footrest Clearance dimensions for sizing of mammography equipment.” Memorandum. April 23, 2013....
-
809.2.2 Turning Space
EXCEPTION: Turning space shall not be required in exterior spaces 30 inches (760 mm) maximum in depth or width. Advisory 809.2.2 Turning Space....
-
Teeing Grounds
A rectangular area usually two club-lengths in depth, the teeing ground’s borders are defined by the outside limits of two “tee-markers.”...
-
5.3.2 Transfer Sides Recommendations for M301
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
5.7.1 Lift Compatibility Clearance in Base for M301
Where the width of the examination surface is less than 36 inches, the clearance depth shall extend the full width of the equipment....
-
809.2.2 Turning Space
EXCEPTION: Turning space shall not be required in exterior spaces 30 inches (760 mm) maximum in depth or width. Advisory 809.2.2 Turning Space....
-
15. Can I store my lift and bring it out only when it is requested by a person with a disability?
In addition, the ADA Standards specify that a lift must be located at the proper water depth and with the necessary space around it to maneuver a wheelchair....