Beds, stretchers, and other types of equipment will have unique features that determine the shapes of their patient support surfaces....
Search Results "Bed Height"
Filters
Commonly Searched Documents
-
FEATURES
-
PUBLIC WAY
of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width and height...
-
CURRENT SITUATION: THE VAST MAJORITY OF EXAMINATION AND PROCEDURES TABLES ARE 32 INCHES HIGH
Figure 1: Percentage of fixed height versus adjustable height medical tables (representing the U.S. install base of medical tables) One of the primary objectives of the U.S....
-
Elevator Car Controls
Comments recommended that the height of elevator car controls be harmonized with the ANSI A117.1 standard....
-
Side guard protocol
Side guard protocol: From initial setup, two side guards adjusted 6” (15.2 cm) higher than the subject’s WMD seat were attached, and subjects were asked to perform a level height transfer...
-
11B-411.2.1.3.2 Touch screen call console arrangement
The accessibility function button shall be located at a height of 36 inches (914 mm) to 42 inches (1067 mm) above the finish floor....
-
11B-411.2.1.3.1 Keypad call console arrangement
The accessibility function button shall be located directly below the keypad at a height of 36 inches (914 mm) to 42 inches (1067 mm) above the finish floor....
-
Public Way
open to the outside air leading to a public street, which has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width and height...
-
Expert Advice of Medical Practitioners
option of a 17 inch high surface would be preferable to a 19 inch height....
-
Hill-Rom Golvo® 8000 / 8008 Patient Lift
The parallel base‐width adjustment facilitates lifting in many different situations; for example, where under‐bed clearance is limited, and lifting to and from chairs....
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
7 Acromion* Heights: Height of Shoulder, Acromial Height, sitting Length/Depth: Length of Clavicle (with sternal notch) JCR: Possible Shoulder JCR 8...
-
Dome Size: ADA Standard Section 705.1.1
a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum to 65 percent of the base diameter maximum, and a height...
-
232 Detention and Correctional Facilities
Several provisions in this section have been revised: this section has been revised to refer to "cells" as opposed to "cells or rooms" for purposes of simplicity scoping for beds...
-
Resources
Beds in Accessible Sleeping Rooms. Retrieved from http://dredf.org/anprm/beds-in-accessible-sleeping-rooms.shtml Open Doors Organization (2001). Press Releases....
-
Integration of inmates and detainees with disabilities. (Section-by-Section Analysis)
individual, a public entity-- (1) Should not place inmates or detainees with disabilities in locations that exceed their security classification because there are no accessible cells or beds...
-
APPENDIX A
The first presentation addressed a number of performance and efficacy considerations for examination chairs focusing on lifting mechanisms to adjust seat height, impact of height on the...
-
Responsibility for supervision and care of a service animal. (Section-by-Section Analysis)
The Department notes that there are occasions when a person with a disability is confined to bed in a hospital for a period of time....
-
Preferred Seat Widths
5th 25th 50th 75th 95th Mini-mum Maxi-mum Level Height...
-
CONTENTS
Tables Available data do not support departing from the currently accepted standard of 19-Inch transfer surface height Adoption of a 19 inch height minimizes costs to health care...
-
2.4.1 Current Marketplace Dynamics
and table minimum heights....
-
309.3 Baby Changing Table Pull Down Handle Height
-
407.12.2 Side Reach (Section-by-Section Analysis)
It proposes to limit the height of the portion of the ICT over which a person must reach to access controls to 34 inches maximum in height....
-
233 Residential Facilities
(1) In sleeping rooms with more than 25 beds covered by this section, a minimum of 5% of the beds shall have clear floor space complying with section 806.2.3 of the 2010 Standards....
