No. In determining whether acquisition of EIT that meets all or part of the applicable technical provisions of the Access Board's standards would impose an undue burden, an agency...
Search Results "One Step Entry"
-
G.6.iii. - Can "significant expense" be established simply by demonstrating that a product that meets the applicable technical provisions is significantly more expensive than one that does not?
- Turnstile Security Systems Inc. 6000 GB 1 Optical Turnstile
- Turnstile Security Systems Inc. 6000 GB 2 Optical Turnstile
-
Mobility
And the emphasis here really has to be on steps, stairs and drop-offs. That’s where the falls occur, either on the top of the steps or the bottom of the steps or off a curb....
-
Taking Photographs
We recommend taking photographs of measurements and noncompliant elements such as steps. It is likely that others may review information about the facility you are surveying. ...
-
Staff Training
Staff Training Providing good training to your staff is perhaps the single most important step you can take towards meeting your ADA obligations....
-
11B-504.2 Treads and risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (102 mm) high minimum and 7 inches (178 mm) high maximum....
-
11B-504.2 Treads and risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (102 mm) high minimum and 7 inches (178 mm) high maximum....
-
§ 38.31(c)
shall have outside light(s) which, when the door is open, provide at least 1 foot-candle of illumination on the street surface for a distance 3 feet (915 mm) perpendicular to the bottom step...
-
11B-504.2 Treads and risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (102 mm) high minimum and 7 inches (178 mm) high maximum....
-
804.2.1 Pass Through Kitchen
Pass through kitchens shall have two entries. Â Â Figure 804.2.1 Pass Through Kitchens...
-
809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
608.2.1 Transfer Type Shower Compartments
shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915 mm) wide minimum entry...
-
§ 37.42(a)
(a) In addition to meeting the requirements of sections 37.9 and 37.41, an operator of a commuter, intercity, or high-speed rail system must ensure, at stations that are approved for entry...
-
1014.2.2 Roll-in Access
Where roll-in access is provided, this section requires a level or sloped entry route complying with the technical requirements for outdoor recreation access routes in 1016 or trails in...
-
§ 37.42(a)
(a) In addition to meeting the requirements of sections 37.9 and 37.41, an operator of a commuter, intercity, or high-speed rail system must ensure, at stations that are approved for entry...
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A. Notes: 1....
-
§ 38.95(a)(1) General
All new commuter rail cars, other than level entry cars, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying with...
- Belson Outdoors Recycled Plastic Universal Access Picnic Table
- SciFit PRO1000 - Seated Upper Body Machine
- Lowes Gatehouse Custom Access Ramp System
- Innerface Parallel Interior Signage
-
12.2 Q. What happens if a builder deliberately manipulates the grade so that a second story, which also might have been treated as a ground floor, requires steps?
A. Deliberate manipulation of the height of the finished floor level to avoid the requirements of the Fair Housing Act would serve as a basis for the Department to determine that...