Water closets not in compartments require clearance that is at least 60 inches wide and 56 inches deep....
Search Results "Knee Clearance"
Filters
Commonly Searched Documents
-
Water Closet Clear Floor Space in Toilet Compartments
-
Recessed Lavatories
In-swinging doors must clear fixture clearances and door clearances must clear the water closet fixture (verify toilet length)....
-
Conclusions
Conclusions Design criteria based on the univariate analysis of abdomen depth is sufficient if all other clearance dimensions are unbounded (i.e., unrestricted) and abdomen depth is the...
-
603.2.3 Door Swing
Doors shall not swing into the clear floor space or clearance required for any fixture. Doors shall be permitted to swing into the required turning space. EXCEPTIONS: 1....
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear wall....
-
Smith System Flex Single-Student Desk with Hard Plastic Top - 01369
Its design moves the support away from the corners so the student has more knee room for easier ingress/egress, saving time she/he stands up or sits down....
-
AquaTrek2 AQ-350 Aquatic Wheelchair
This model is ideal for tall adults to create a proper bent knee position....
-
AquaTrek2 AQ-250PC Aquatic Wheelchair
This model is ideal for tall adults to create a proper bent knee position....
-
AquaTrek2 AQ-150 Child Size Aquatic Wheelchair
This model is ideal for tall adults to create a proper bent knee position....
-
4.2.4.1 SIZE AND APPROACH
Clear floor or ground space for wheelchairs may be part of the knee space required under some objects. Figure 4 Minimum Clear Floor Space for Wheelchairs...
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADA Standards....
-
Water Closet Clear Floor Space
Clearance requirements for water closets are covered in section 604.3....
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
§ 38.25(c) Door height
For vehicles in excess of 22 feet in length, the overhead clearance between the top of the door opening and the raised lift platform, or highest point of a ramp, shall be a minimum of 68...
-
11B-813.2.10 Door swing
Where a clear floor space complying with Section 11B-305.3 is provided within the room beyond the arc of the door swing, doors shall be permitted to swing into the clear floor space, clearance...
-
11B-302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3 _|Platform to Hoistway Clearance|_,...
-
Cybex Total Access Seated Leg Curl Exercise Machine
Thigh Pad Clamping Mechanism Thigh pad hold-down mechanism allows the thighs to be secured above the knee for reduced shear force on the knee joint while keeping it in a stable position...
-
Cybex Total Access Lat Pull Exercise Machine
Adjustable Knee Restraint Adjustable knee restraint and seat height allows shorter users and others with reduced trunk stability to maintain full flat foot contact with the floor....
-
TTY Access at Wheelchair Accessible Phones
They may also obstruct front approach knee space below phones for people using wheelchairs....
-
R210.3 Shared Use Paths
The AASHTO Guide recommends 10 feet vertical clearance along shared use paths, and 8 feet minimum vertical clearance in constrained areas....
-
Floor and Ground Surfaces
apply to: interior and exterior accessible routes, including walking surfaces, ramps, elevators, and lifts stairways that are part of a means of egress required clearances...
-
Overview
There also needs to be enough knee and toe clearance to ensure that the patient can get close enough to the breast platform without knees or feet hitting parts of the equipment....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
