1.1.3 A maximum overall design running slope for exterior accessible surfaces (other than ramps), such as sidewalks, of 4% (approximately 1:25) is recommended....
Search Results "Transfer Surface"
-
1.1.3
-
11B-502.4 Floor or ground surfaces
Advisory 11B-502.4 Floor or ground surfaces. Access aisles are required to be nearly level in all directions to provide a surface for wheelchair transfer to and from vehicles....
-
Firmness
The degree of surface resistance to deformation, especially by indentation or the movement of objects (U.S. Access Board, 2007)....
-
606.5 Exposed Pipes and Surfaces
There shall be no sharp or abrasive surfaces under lavatories and sinks...
-
804.3 Kitchen Work Surface
In residential dwelling units required to comply with 809, at least one 30 inches (760 mm) wide minimum section of counter shall provide a kitchen work surface that complies with 804.3....
-
804.3 Kitchen Work Surface
In residential dwelling units required to comply with 809, at least one 30 inches (760 mm) wide minimum section of counter shall provide a kitchen work surface that complies with 804.3....
-
b. Positioning Supports
(Section-by-Section Analysis – M305.2), the MDE Advisory Committee made recommendations to add requirements for positioning supports on mammography equipment and imaging equipment with transfer...
-
606.5 Exposed Pipes and Surfaces
There shall be no sharp or abrasive surfaces under lavatories and sinks. [ECTCR UFAS 4.19.4, 4.24.6, 4.34.6.5(8)]...
-
17. Can broken or older ground level play components be replaced without changing the surface?
Can broken or older ground level play components be replaced without changing the surface? Yes....
-
Clear Deck Space
Clear Deck Space Clear deck space of 60 by 60 inches minimum, with a slope of not more than 1:48, must be provided at the base of a transfer wall....
-
Stable
A surface is not permanently affected by expected weather conditions and can sustain normal wear and tear from the expected use(s) of the area, between planned maintenance....
-
Shower
Although not a transfer issue, lowered sidewalls were intended to facilitate assisted showering....
-
Data Collection Procedures
study surfaces. ...
-
11B-606.5 Exposed pipes and surfaces
11B-606.5 Exposed pipes and surfaces. Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
Installation
PIP was exclusively installed by contractors specializing in the surface material. ...
-
2) Where the Standard says "Changes in level are not permitted"
permitted", such as 304.2 for turning spaces: Here the standard is followed by an unenforceable advisory that says, "As used in this section, the phrase ‘changes in level’ refers to surfaces...
-
11B-226.2 Dispersion
Dining surfaces required to comply with Section 11B-902 shall be dispersed throughout the space or facility containing dining surfaces for each type of seating in a functional area....
-
11B-226.2 Dispersion
Dining surfaces required to comply with Section 11B-902 shall be dispersed throughout the space or facility containing dining surfaces for each type of seating in a functional area....
-
11B-226.2 Dispersion
Dining surfaces required to comply with Section 11B-902 shall be dispersed throughout the space or facility containing dining surfaces for each type of seating in a functional area....
-
Hager Companies Door Protection Plate 198S
Door Protection Plate 198S 0.038" gauge stainless steel Materials: - Stainless Steel
-
Hager Companies Door Protection Plate 194S
Door Protection Plate 194S 0.050" gauge with 4-sided bevel Materials: - Aluminum, Brass, Bronze, Stainless Steel
-
Hager Companies Door Protection Plate 220S
Door Protection Plate 220S 0.062" gauge with no bevel Materials: - Aluminum, brass, bronze, stainless steel Options: - Self-adhesive tape available on all plates -...
-
Hager Companies Door Protection Plate 190S
Door Protection Plate 190S 0.050" gauge with no bevel Options: - UL listed for US32 and US32D with screw fasteners (must specify UL stamp) - Self-adhesive tape available...
-
Hager Companies Door Protection Plate 223S
Door Protection Plate 223S 0.062" gauge with 3-sided bevel Materials: - Aluminum, brass, bronze, stainless steel Options: - Self-adhesive tape available on all plates -...
