Sections are engineered to provide ground protection and access over soft surfaces and will provide a firm support base and traction for numerous activities....
Search Results "Kitchen Work Surface"
Commonly Searched Documents
- AccessRec DuraDeck 2 Molded Plastic Mat Ground Surface
- Tile Tech Pavers® Coral-Pave™
-
Seat Width Evaluation
many participants (the 25th through 95th percentiles) for their level, highest and lowest height transfer regardless of the presence or absence of grab bars or a backrest on the transfer surfaces...
-
§ 38.23(c)(2) Ramp surface
(2) Ramp surface....
-
§ 38.83(c)(2) Ramp surface
(2) Ramp surface....
-
5.2.3 Transfer Surface Measurement
5.2.3 Transfer Surface Measurement. The transfer surface should be measured from the center-point of each side of the transfer surface....
-
Slope
The 2010 Standards provide, at section 403.3, that the cross slope of walking surfaces not be steeper than 1:48....
-
§ 38.125(c)(2) Ramp surface
(2) Ramp surface....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
Inpro Corporation IPC® Designer Kickplates Models 10 & 20
Requires the Premium User plan or above. (Login or upgrade your account!)
- Tile Tech Pavers® IPE Deck Tiles
-
1005.3.2 Extended Ground or Deck Surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
Visible Alarms
These commenters also raised concerns that all employee work areas within existing buildings and facilities must be equipped with accessibility features....
- Husky 10" Multi-Function Standard Digital Level
-
5.2.2.1 Transfer Surface Width Recommendations for M302
5.2.2.1 Transfer Surface Width Recommendations for M302 The Committee recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily...
- Filter Pave™ Porous Paving for Stormwater Management Informational Video
-
1.2.2
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
-
502.4 Floor or Ground Surfaces
502.4 Floor or Ground Surfaces. Parking spaces and access aisles serving them shall comply with 302. Access aisles shall be at the same level as the parking spaces they serve....
-
Executive Summary
After traveling over each surface, subjects were asked to subjectively rate each surface and decide whether the surface was acceptable or not....
-
Question 2
Are the surfaces of all elements of the parking area and accessible route smooth and free of large cracks and broken or raised areas?...
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
- Tile Tech Pavers® Oceanic™ Series - Wave-Pave™
-
Tiles
TIL was the most expensive of the five types of surfaces identified for study. ...
-
Q2: Milling a Road Surface
Q2: The Joint Technical Assistance states that “[r]esurfacing is an alteration that triggers the requirement to add curb ramps if it involves work on a street or roadway spanning from one...