At each location where there are railings, guards, or handrails complying with Section 11B-1005.2.1, a clear floor or ground space complying with Section 11B-305 shall be provided....
Search Results "High Speed Rail"
-
11B-1005.4 Clear floor or ground space
-
11B-1005.4 Clear floor or ground space
At each location where there are railings, guards, or handrails complying with Section 11B-1005.2.1, a clear floor or ground space complying with Section 11B-305 shall be provided....
-
11B-604.4 Seats
Seats shall be 2 inches (51 mm) high maximum. [2010 ADA Standards] 604.4 Seats....
-
11B-604.4 Seats
Seats shall be 2 inches (51 mm) high maximum. [2010 ADA Standards] 604.4 Seats....
-
1.6.5 Designated Public Transportation.
Transportation provided by a public entity (other than public school transportation) by bus, rail, or other conveyances (other than transportation by aircraft or intercity or commuter rail...
-
12182(b)(2)(A)(iv)
(iv) a failure to remove architectural barriers, and communication barriers that are structural in nature, in existing facilities, and transportation barriers in existing vehicles and rail...
-
Section 37.59 Differences in Accessibility Completion Date Requirements
., there is no need to install an elevator, and platform accessibility can be achieved by use of a relatively inexpensive mini-high platform)....
-
Section 37.35 Supplemental Service for Other Transportation Modes
Another instance is one in which a commuter rail operator uses fixed route bus service as a dedicated connection to, or extension of, its rail service....
-
11B-809.8.1 Door Thresholds
Secondary exterior door thresholds, including sliding door tracks, shall be 3/4 inch (19.1 mm) high maximum with a 1:2 maximum slope....
-
Examination Tables
Power tables have an electric motor that can adjust the table height to as low as 18 inches and as high as 40 inches above the floor on some products....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz...
-
Recumbent Bicycles
This typically results in slower acceleration from stops and the need for lower gears on hills, resulting in slower climbing speeds....
-
Magnuson Group DACAPO Brochure & Leaflet Holders
Wall mounted rail with two 8 1/4”W x 11 11/16”H polystyrene brochure holders. Silver Anodized Aluminum rail with clear pockets....
-
R305.1.4 Size
At pedestrian at-grade rail crossings not located within a street or highway, detectable warnings shall extend the full width of the crossing....
-
Beneficial Designs High Efficiency Trail Assessment Process (HETAP) Software 3.0 Wheeled Instrumentation Sensor Package for Data Collection
Key HETAP and UTAP Differences HETAP follows the same general principles as its predecessor, UTAP (the Universal Trail Assessment Process). Both collect objective trail...
-
1005.3.2 Extended Ground or Deck Surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
T213.2 Priority Seats
Non-rail vehicles operated in fixed-route service shall designate at least two seats as priority seats for passengers with disabilities....
-
12147(b)(2)(A) Accessibility
(A) Accessibility Except as otherwise provided in this paragraph, all key stations (as determined under criteria established by the Secretary by regulation] in rapid rail and light rail...
-
12141(2) Designated public transportation
(2) Designated public transportation The term "designated public transportation" means transportation (other than public school transportation) by bus, rail, or any other conveyance (...
-
PUBLIC ENTITY
other instrumentality of a State or States or local government; and (3) The National Railroad Passenger Corporation, and any commuter authority (as defined in section 103(8) of the Rail...
-
PUBLIC ENTITY
other instrumentality of a State or States or local government; and (3) The National Railroad Passenger Corporation, and any commuter authority (as defined in section 103(8) of the Rail...
-
11B-904.4.2 Forward approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum shall be provided....
-
11B-904.4.2 Forward approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum shall be provided....
-
Shape and Diameter
Use of a handrail requires the formation of a power grip so that hands and fingers can be opposed and the surface of the palm can be in maximum contact with the rail surface....
