The Impact of Transfer Setup on the Performance of Independent Transfers: Final Report REPORT PREPARED FOR: U.S. ACCESS BOARD, WASHINGTON, DC ย Authors: Alicia Koontz, PhD,...
Search Results "Diagonal Curb Ramp"
Commonly Searched Documents
-
The Impact of Transfer Setup on the Performance of Independent Transfers: Phase I Final Report
-
5. Edge Protection
The MDE NPRM proposed edge protection on the ramps leading up to the raised platform (proposed M303.3.3.4), but did not require edge protection on the raised platforms themselves....
-
ยง 382.40 Boarding assistance for small aircraft
(b) Carriers shall, in cooperation with the airports they serve, provide boarding assistance to individuals with disabilities using mechanical lifts, ramps, or other suitable devices that...
-
1002.2 Accessible Routes
In load or unload areas and on amusement rides, where compliance with 405.2 is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum. 2....
-
1002.2 Accessible Routes
In load or unload areas and on amusement rides, where compliance with 405.2 is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum. 2....
-
1002.2 Accessible Routes
In load or unload areas and on amusement rides, where compliance with 405.2 is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum. 2....
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
-
11B-1002.2 Accessible routes
Exceptions: In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 is not structurally or operationally feasible, ramp slope shall be permitted...
-
Exceptions Considered for Wheelchair Spaces on Raised Platforms
The exception to the minimum width in M303.2.2 would apply where ramped surfaces are provided on the opposite sides of the raised platform so that patients using wheelchairs can enter and...
-
Entrances
Temporary Solutions The use of temporary ramps can provide access over steps or high thresholds....
-
4.1.7(2)(a)(ii) ADA Application
If the State Historic Preservation Officer or Advisory Council on Historic Preservation agrees that compliance with the requirements for accessible routes (exterior and interior), ramps,...
-
T502.2.1 Over-the-Road Buses
For over-the-road buses, the vertical clearance at doorways shall be 65 inches (1650 mm) minimum.
- SafetyStepTD Ramp-Up Detectable Warning System
-
3) Where the standard says "Changes in level are not permitted", but no advisory follows the standard
305.2, 405.4, and 802.1.1 Does it apply in similar sections that also say "changes in level are not permitted" but are not described/listed in the advisory at 304.2, such as 405.7.1 at ramp...
-
2. Standing Supports
The Committee recommended that for single-ramped entry raised platforms with wheelchair spaces, the standing supports located on two sides of the platform have a minimum of 34 inches between...
-
ยง27.75(a)(2) Curb cuts.
(2) Curb cuts....
-
H. Your Obligation to Provide Services and Equipment
[Sec. 382.39(a)] More specifically, you must provide, as needed, the following: services personnel ground wheelchairs boarding wheelchairs ramps or mechanical...
-
1023.9 Stairway identification signs
A sign shall be provided at each floor landing in an interior exit stairway and ramp connecting more than three stories designating the floor level, the terminus of the top and bottom of...
- Accessible Pittsburgh: The One Step Project
- PlayLSI: A Higher Level of Inclusive Play
- Retail Store Disability Access; Dawn Secret Treasures: BigBell
-
10.3.2(2)
(2) The accessible route required by 10.3.2(1) shall include the features specified in 10.3.1(1), (4)-(9), (11)-(15), and (17)-(19).