In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
Search Results "Curb Ramp"
Commonly Searched Documents
-
11B-1002.2 Accessible routes
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
-
11B-1002.2 Accessible routes
Exceptions: In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 is not structurally or operationally feasible, ramp slope shall be permitted...
-
Exceptions Considered for Wheelchair Spaces on Raised Platforms
The exception to the minimum width in M303.2.2 would apply where ramped surfaces are provided on the opposite sides of the raised platform so that patients using wheelchairs can enter and...
-
Entrances
Temporary Solutions The use of temporary ramps can provide access over steps or high thresholds....
-
4.1.7(2)(a)(ii) ADA Application
If the State Historic Preservation Officer or Advisory Council on Historic Preservation agrees that compliance with the requirements for accessible routes (exterior and interior), ramps,...
-
T502.2.1 Over-the-Road Buses
For over-the-road buses, the vertical clearance at doorways shall be 65 inches (1650 mm) minimum.
-
3) Where the standard says "Changes in level are not permitted", but no advisory follows the standard
305.2, 405.4, and 802.1.1 Does it apply in similar sections that also say "changes in level are not permitted" but are not described/listed in the advisory at 304.2, such as 405.7.1 at ramp...
- SafetyStepTD Ramp-Up Detectable Warning System
-
2. Standing Supports
The Committee recommended that for single-ramped entry raised platforms with wheelchair spaces, the standing supports located on two sides of the platform have a minimum of 34 inches between...
-
§27.75(a)(2) Curb cuts.
(2) Curb cuts....
-
H. Your Obligation to Provide Services and Equipment
[Sec. 382.39(a)] More specifically, you must provide, as needed, the following: services personnel ground wheelchairs boarding wheelchairs ramps or mechanical...
-
1023.9 Stairway identification signs
A sign shall be provided at each floor landing in an interior exit stairway and ramp connecting more than three stories designating the floor level, the terminus of the top and bottom of...
- Accessible Pittsburgh: The One Step Project
- PlayLSI: A Higher Level of Inclusive Play
- Retail Store Disability Access; Dawn Secret Treasures: BigBell
-
10.3.2(2)
(2) The accessible route required by 10.3.2(1) shall include the features specified in 10.3.1(1), (4)-(9), (11)-(15), and (17)-(19).
-
Circular Cross Section and Clearance (§505.5, §505.7)
Circular Cross Section and Clearance (§505.5, §505.7)
- EZ Launch for Kayaks and Canoes with Accessible Transfer Bench
-
Ramp
Ramp: A ramped surface was designed to insert between two steps and serve as an integrated sliding board to assist with the transfers by bridging the gap between steps. ...
-
§ 37.42(f)
vertical gap is more than 5/8 inch, measured when the vehicle is at rest, the horizontal and vertical gaps between the car floor and the boarding platform must be mitigated by a bridge plate, ramp...
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms.
-
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height. Edge protection is not required on platforms 1 ½ inches or less in height.