Color coding shall be placed immediately above the control button. Control buttons shall be located no higher than 48 inches (1219 mm) above the ground surface adjacent to the pole....
Search Results "Cast-in-Place"
Commonly Searched Documents
-
11B-703.7.2.7 Pedestrian traffic-control buttons
-
11B-411.2.3.2 Car designation signs
Braille complying with Section 11B-703.3 shall be placed below the corresponding raised characters. Applied plates are acceptable if they are permanently fixed to the jamb....
- American Specialties Surface Mounted Roll Paper Towel Holder 8165
- Gamco Heavy-Duty Clothes Hook with Concealed Mounting - B-2116
-
11B-224.1 General
For ADA scoping requirements of Title III §36.406(c) Standards for New Construction and Alterations; Places of Lodging, and also Title II §35.151(f) and Title III §36.406(e) Standards for...
-
1117B.5.5, Item 4
Braille shall be placed a minimum of 3/8 inch (9.5 mm) and a maximum of 1/2 inch (12.7 mm) directly below the tactile characters; flush left or centered....
-
224.1 General
Places of lodging and housing at a place of education shall comply with the provisions applicable to transient lodging, including, but not limited to, the requirements for transient lodging...
-
UFAS vs. ADAAG Comparison - Assembly Seating
1,000. 20 plus 1 for each 100 over 1,000. 11, plus 1 add'l.space for each total seating capacity increase of 100 UFAS scoping language: 4.1.2(18)(a) If places...
-
C.2. - If EIT is acquired through another agency’s contract, which agency is responsible for Section 508 compliance?
In addition, if the servicing agency places the order on the requiring agency’s behalf, the servicing agency needs to take necessary management steps before placing the order to ensure that...
-
3.3 Equipment Barriers and Solutions
Purchase equipment with tactile displays and/or audible (sound) output Unable to locate pin and make other adjustments to equipment Place high-contrast and tactile labels...
-
11B-224.1 General
For ADA scoping requirements of Title III §36.406(c) Standards for New Construction and Alterations; Places of Lodging, and also Title II §35.151(f) and Title III §36.406(e) Standards for...
-
11B-809.10.7.3 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Where water closets are not placed adjacent to a side wall capable of accommodating a grab bar, the bathroom shall...
-
11B-224.1 General
Access Board's Note To Reader after Section 224.5 for ADA scoping requirements of Title III §36.406(c) Standards for New Construction and Alterations; Places of Lodging, and also Title II...
-
M305.2.8 Fittings (Section-by-Section Analysis)
The MDE Advisory Committee recommended amending this provision to allow transfer supports to rotate in their fittings, but to require that they not rotate when they are locked into place...
-
M301.4 Lift Compatibility
With a short wheelbase, one leg of a floor based mobile patient lift will be placed through the base and the second leg of the lift will be placed around the base....
-
TITLE III COVERAGE
C.F.R. pt. 36, prohibit discrimination on the basis of disability in the full and equal enjoyment of the goods, services, facilities, privileges, advantages, and accommodations of any place...
-
221.2.3.2 Vertical Dispersion
When wheelchair spaces are dispersed vertically in an assembly facility they are placed at different locations within the seating area from front-to-back so that the distance from the screen...
-
F. Shelter Environment
This requirement extends beyond the “accessible route” and applies throughout the shelter environment to any place where a person can walk....
-
Clear floor space
(30" + 48") This could also be accomplished if a bench with fixed back was placed in front of lockers at the end of a row of benches opposite the accessible lockers. ...
- inLOOP Personal Loop Portable Assistive Listening System
- Bobrick Recessed Multi-Roll Toilet Tissue Dispenser B-4388
- Pilot Rock Smoker's Cease Fire Ash Receptacle
- AbleRoad™ App
- Excel Dryer, Inc. LEXAN® Series Hand Dryers