Exceptions: The space between the grab bars and shower controls, shower fittings, and other grab bars above shall be permitted to be 1½ inches (38 mm) minimum....
Search Results "Bathtub Control"
-
11B-609.3 Spacing
-
11B-609.3 Spacing
Exceptions: The space between the grab bars and shower controls, shower fittings, and other grab bars above shall be permitted to be 1½ inches (38 mm) minimum....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm) minimum...
- Wikk Industries Inc. Bollard With Push Plate PART# BPS SM PRP36 CL (628)
- Wikk Industries Inc. Bollard With Push Plate PART# BPS SM TUBE 32D (630)
-
Issue 7: Repair/replacement (put it back right!)
After reinstallation, the APS was turned 90 degrees from its prior placement, and the tactile arrow was no longer pointing at the street the pushbutton controlled....
-
Utility and Sewage Hookups [1011.2, 1011.3, and 1011.6]
At utility hookups, such as electrical service, water, cable or Internet connections, in camping units with mobility features and at sewage hookups in dump stations, a minimum of...
-
Operation
The controls and operating mechanisms must be unobstructed when a lift is in use....
-
608.5.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
- Kohler Washdown Urinal Flushometer Valve K-13518-CP
-
F224.2 Guest Rooms with Mobility Features
In transient lodging facilities, guest rooms with mobility features complying with 806.2 shall be provided in accordance with Table F224.2. [ECTCR UFAS 4.1.4(11)(a) depending on...
-
224.2 Guest Rooms with Mobility Features
In transient lodging facilities, guest rooms with mobility features complying with 806.2 shall be provided in accordance with Table 224.2. EXCEPTIONS: 1. Facilities on a...
-
224.2 Guest Rooms with Mobility Features
224.2 Guest Rooms with Mobility Features. In transient lodging facilities, guest rooms with mobility features complying with 806.2 shall be provided in accordance with Table...
-
Phones
Phones Permanently installed telephones must be equipped with a volume control....
- BTX Intelligent Fashion Motorized Roller Shades
- BTX Intelligent Fashion Tumo Drapery System
-
Verify Electrical
Measure to top or bottom of boxes 11B-308.1.2 Alarm/detector systems. 11B-702 Height of HVAC controls....
-
Verify Electrical
Measure to top or bottom of boxes 11B-308.1.2 Alarm/detector systems. 11B-702 Height of HVAC controls....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm)...
-
§ 38.127(c)
(c) Controls and operating mechanisms (e.g., heating and air conditioning controls, lighting controls, call buttons, electrical outlets, etc.) shall be mounted no more than 48 inches, and...
- 309.4 Accessible Low Drinking Fountain Operation
-
§382.57(c)(6) Input
(6) Input. Input devices must comply with paragraphs (c)(6)(i) through (iv) of this section.
-
§382.57(c)(6)(iv)(B) Tactile symbols
(B) Tactile symbols. Function key surfaces must have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised...
-
§382.57(c)(7)(ii) Characters
(ii) Characters. Characters displayed on the screen must be in a sans serif font. Characters must be 3/16 inch (4.8 mm) high minimum based on the uppercase letter “I.” Characters...