Search Results "Trail Surface"

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.1 Transfer Surface Height Adjustability

  5.1.1 Transfer Surface Height Adjustability. The transfer surface should have an adjustable height in small virtually continuous increments....

• Federal Documents > Technical Assistance > 2013 Forest Service Outdoor Recreation Accessibility Guidelines (FSORAG)
  4.3.3 Slope

  When the surface is not paved or is not elevated above the natural ground, slopes not steeper than 1:33 (3 percent) shall be permitted where necessary for drainage. ...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.2 Transfer Surface High Height

  5.1.2 Transfer Surface High Height. The transfer surface should have an adjustable height range with an upper height measuring at least 25 inches....

• Research and History > Research Documents > Visual Detection of Detectable Warning Materials by Pedestrians with Visual Impairments - Final Report
  1.5 Materials

  Four different colors of simulated sidewalk surfaces were used in this study....

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  405.3 Cross Slope

  Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....

• Additional Access Publications > Proceedings of: Workshop on Improving Building Design for Persons with Low Vision
  Avoid the extremes of surface reflectivity and contrast (slides 11 and 13)

  We don’t have to have highly reflective surfaces that will still reflect light but spread it, diffuse that light instead of pinpoint reflections....

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  1133A.4.1 Exceptions

  Two 15-inch (381 mm) wide minimum breadboards may be provided in lieu of the required 30 inches (762 mm) of countertop work surface, and used without meeting the repositioning requirements...

• Products and Additional Resources > Survey and Plan Review Tools > ETA Survey and Plan Review Tools
  2010 ADA Standards - Plan Review Tool - Slopes

  2010 ADA Standards - Plan Review Tool - Slopes Click here to view/download the pdf "2010 ADA Standards - Plan Review Tool - Slopes" (774 KB) * * * * * * *

• State and Local Documents > Codes and Standards > 2019 California Standards
  11B-804.3 Kitchen work surface

  In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-813.2.1.2 Clearance

  Floor or ground surfaces of clearances shall comply with Section 11B-302. Changes in level are not permitted....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1 Transfer Surface Height

  5.1 Transfer Surface Height...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  National Network of ADA Centers

  The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor to the top of the transfer surface....

• Products and Additional Resources > Survey and Plan Review Tools > CASI Accessibility Construction Inspection Checklist
  Built-in Elements

  BUILT-IN ELEMENTS Dining/work surfaces 11B-226, 11B-902.2 Benches 11B-903.2...

• Products and Additional Resources > Survey and Plan Review Tools > CALBO Accessibility Construction Inspection Checklist
  Built-in Elements

  BUILT-IN ELEMENTS Dining/work surfaces 11B-226, 11B-902.2 Benches 11B-903.2...

• Research and History > Research Documents > Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
  Transfer Protocols

  After each transfer in each protocol, any changes made to device positioning (if any), use of a transfer board, and surface(s) used for the leading hand (e.g. reaching to new surface) and...

• Products and Additional Resources > Products
  Sears Brands, LLC Craftsman Digital Torpedo Level
  

  Description Item # 00948295000P Model # 48295 Craftsman Digital Torpedo Level Keeps It Plumb, Even in Tight Spaces The Digital Torpedo takes the guesswork out of reading...

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  226.1 General

  Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with 902....

• Products and Additional Resources > Products
  SafePath SAFELIFT™ Platform Weightlifting Surface
  

  The new the SafeLift™ Platform reinvents the Crossfit weightlifting Platform. More durable than other models, the new SafeLift™ Platform is made from 100% recycled rubber and is...

• Federal Documents > Technical Assistance > Outdoor Developed Areas: A Summary of Accessibility Standards for Federal Outdoor Developed Areas
  Fire Rings, Grills, Fireplaces, and Woodstoves [1011.2, 1011.3, and 1011.5]

  The fire-building surface within a fire ring must be at least 9 inches above the ground (figure 20)....

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  810.5.1 Slope

  810.5.1 Slope. Rail platforms shall not exceed a slope of 1:48 in all directions. EXCEPTION: Where platforms serve vehicles operating on existing track or track laid in existing...

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  810.5.1 Slope

  Rail platforms shall not exceed a slope of 1:48 in all directions. EXCEPTION: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  11B-810.5.1 Slope

  Rail platforms shall not exceed a slope of 1:48 in all directions. Exception:  Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  810.5.1 Slope

  Rail platforms shall not exceed a slope of 1:48 in all directions. EXCEPTION: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1190, Proposed Accessibility Guidelines for Pedestrian Facilities in the Public Right-of-Way: Notice of Proposed Rulemaking (NPRM)
  R407.6.1 Slope

  R407.6.1 Slope. Landing slopes shall be 2 percent maximum in any direction.