The requirement that wheelchair spaces be an "integral part of the seating plan" means that wheelchair spaces must be placed within the footprint of the seating area....
Search Results "Patient Change Area"
-
11B-221.2.2 Integration
-
11B-221.2.2 Integration
The requirement that wheelchair spaces be an "integral part of the seating plan" means that wheelchair spaces must be placed within the footprint of the seating area....
-
Maneuvering Space in Load and Unload Areas
Maneuvering Space in Load and Unload Areas....
-
11. Outside of the Service Area or Operating Hours
A person's request for fixed route or paratransit service may be denied when honoring the request would require the transportation provider to travel outside of its service area or to operate...
-
R308.1.1.1 Dimensions
Boarding and alighting areas shall provide a clear length of 2.4 m (8.0 ft) minimum, measured perpendicular to the curb or street or highway edge, and a clear width of 1.5 m (5.0 ft) minimum...
-
Figure M1: Overview of M301 Diagnostic Equipment for Use by a Patient in a Supine, Prone, or Side-Lying Position
[See subsections ...]
-
F244.3 Outdoor Constructed Features in Common Use and Public Use Areas
Where provided in common use and public use areas that serve camping units with mobility features, at least 20 percent, but not less than one, of each type of outdoor constructed feature...
-
M301.2 Transfer Surface
A transfer surface shall be provided and shall comply with M301.2.
-
M301.2.3 Size
The size of the transfer surface shall comply with M301.2.3.1 or M301.2.3.2. The size of transfer surfaces shall be measured from center points of their opposing sides.
-
5.2.1 Transfer Surface Size
5.2.1 Transfer Surface Size
-
5.2 Transfer Surface Size Recommendations
5.2 Transfer Surface Size Recommendations
-
M301.2.2 Size
The transfer surface shall be 30 inches (760 mm) wide minimum and 15 inches (381mm) deep minimum. Advisory M301.2.2 Size. The size requirements in this section apply only to the...
-
M301.2 Transfer Surface
A transfer surface shall be provided and shall comply with M301.2.
-
M302.1 General (Section-by-Section Analysis)
The MDE NPRM proposed that all diagnostic equipment used by patients in a seated position must comply with the technical requirements of proposed section M302....
-
F245.4.2 Routes to and Within Common Use and Public Use Areas
Common use and public use areas serving picnic units with mobility features shall provide outdoor recreation access routes in accordance with F245.4.2....
-
5.7.1.2 Lift Compatibility Clearance in Base for Imaging Equipment
5.7.1.2 Lift Compatibility Clearance in Base for Imaging Equipment. An overhead lift may be used as an alternative option in lieu of the provisions for clearances in and around the...
-
ALTERATION
Examples of a change in occupancy or use include the following: changing a patient bedroom to a storage room; changing a nursing service space to an administrative space; changing an intensive...
-
11B-1002.3 Load and unload areas
A turning space complying with Sections 11B-304.2 and 11B-304.3 shall be provided in load and unload areas....
-
11B-1002.3 Load and unload areas
A turning space complying with Sections 11B-304.2 and 11B-304.3 shall be provided in load and unload areas....
-
11B-1002.3 Load and unload areas
A turning space complying with Sections 11B-304.2 and 11B-304.3 shall be provided in load and unload areas....
-
Lines of Sight at Dining Areas in Sports Venues
These comments pointed out that it is difficult to provide accessible routes to much of the seating in such dining areas. Response....
-
(2) Accessible and usable public and common use areas
The Option One guidelines for public and common use areas remain unchanged in the final Guidelines....
-
Dispersion
Commenters with disabilities supported a requirement for dispersion of accessible sleeping rooms among all types of medical specialty areas, such as obstetrics, orthopedics, pediatrics,...
-
M305.2.2.1 End Transfer Supports
Transfer supports for transfer surfaces complying with M301.2.3.1 and M305.2.2.1 shall be 15 inches (380 mm) long minimum. Transfer supports shall be positioned along 13 ½ inches...