All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
Search Results "End of Row Compartment"
-
104.1.1 Construction and Manufacturing Tolerances
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
Purchasing Multiple Tickets
People purchasing a ticket for an accessible seat may purchase up to three additional seats for their companions in the same row and these seats must be contiguous with the accessible seat...
-
§ 37.91(d)
(d) Unless not practicable, a person providing intercity rail transportation shall place an accessible car adjacent to the end of a single level dining car through which an individual who...
-
Tork Elevation® Matic® Hand Towel Roll Dispenser with Intuition® Sensor, Black
An adjustable towel length of 8 inches to 24 inches, and a stub roll compartment combine to deliver more precise control of consumption are a few of the features available....
-
Safety
For example, if an FAA safety rule provides that only persons who can perform certain functions can sit in an exit row, then you can request that an individual unable to perform those functions...
-
608.2.2.1 Clearance
A 30 inch (760 mm) wide minimum by 60 inch (1525 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
-
608.2.2.1 Clearance
A 30 inch (760 mm) wide minimum by 60 inch (1525 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
-
11B-216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with Section 11B...
-
11B-216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with Section 11B...
-
12 [§ 4.7.9]
12 [§ 4.7.9] When a curb ramp is located at a marked crossing, the area where the ramp run ends must be contained within the marked crossing....
-
4.20.3 Seat
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
4.20.3 SEAT
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
block blast online
The goal is to create complete horizontal rows or vertical columns to score points....
-
§100.7(a)(2)
(2) For purposes of determining liability under paragraphs (a)(1)(ii) and (iii) of this section, prompt action to correct and end the discriminatory housing practice may not include any...
-
Parallel Parking Spaces (R309.2) (Section-by-Section Analysis)
In alterations where the street or sidewalk adjacent to the parking spaces is not altered, an access aisle is not required provided the parking spaces are located at the end of the block...
-
5.3.2.1 Transfer Sides Recommendation for Stretchers
The configuration of stretchers typically does not allow access to a transfer surface on either end....
-
4.4.4 Clear Floor or Ground Space
A clear floor or ground space of 36 inches (915 mm) by 48 inches (1220 mm) shall be located at an end the bench with one side of the space adjoining an accessible route, outdoor recreation...
-
4.34.5.4(2) Seat
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
M305.3.2 Vertical Position
Where the support is vertical, it shall be 18 inches (455 mm) minimum in length and the bottom end of the support shall be 34 inches (865 mm) high minimum and 37 inches (940 mm) high maximum...
-
Wheelchairs
storage in the cabin of wheelchairs or components of wheelchairs, including folding, collapsible, or breakdown battery-powered wheelchairs [Sec. 382.41(e)] as follows: • In overhead compartments...
-
Taking Measurements
Rest one end of the level at the highest point of the sloped surface and lift the other end (as shown in the illustration) until the bubble is in the middle of the tube....
-
Georgia-Pacific SmartStock® Classic Heavy-weight Polystyrene Multi-purpose Spoon Dispenser
Now cutlery stays organized in precise rows, inside a clean-line modular dispenser. It's quick and easy and keeps staff focused on productive takes....
-
Georgia-Pacific SmartStock® Classic Heavy-weight Polystyrene Knife Dispenser
Now cutlery stays organized in precise rows, inside a clean-line modular dispenser. It's quick and easy and keeps staff focused on productive takes....
