The side wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall...
Search Results "Audible Sign System"
-
11B-604.5.1 Side wall
-
11B-604.5.1 Side wall
The side wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall...
-
11B-215.5 Residential facilities
Where provided in residential dwelling units required to comply with Section 11B-809.5, fire alarms shall comply with Chapter 9, Section 907.5.2.3.3 and carbon monoxide alarms shall...
-
inLOOP Commercial Use Loop Listener #01115
The personal loop receiver makes it possible for someone without a T-Coil equipped hearing aid to take advantage of the sound broadcast in a loop system....
-
Federal Signal PS Series Push Button Stations Fire Alarm
The Federal Signal push-button stations function like a traditional fire alarm "pull station", providing a simple contact closure to activate emergency equipment, audible and visual signals...
-
205 Operable Parts
controls) shall comply with 4.27. 4.27.3 Exception: These requirements do not apply where the use of special equipment dictates otherwise or where electrical and communications systems...
-
Figure 1003.3.1 (Exception 1) Clear Pier Space Reduction at Boat Slips – Drawing from the U.S. Access Board
-
Figure 1003.3.1 Boat Slip Clearance – Drawing from the U.S. Access Board
-
Figure 1003.3.1 (Exception 2) Edge Protection at Boat Slips – Drawing from the U.S. Access Board
-
Subtitle B: Public Transportation
vehicles, make good faith efforts to purchase or lease accessible used buses, remanufacture buses in an accessible manner, and, provide paratransit where they operate fixed-route bus or rail systems...
-
706.6 Peak Clipping Level
Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech. [ECTCR UFAS 4.33.7]
-
708.3 Handsets
Handset cords, if provided, shall be 29 inches (735 mm) long minimum.
-
§382.83 Through what mechanisms do carriers make seating accommodations?
[See subsections ...]
-
11B-706.6 Peak clipping level
Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech.
-
382.83 Through what mechanisms do carriers make seating accommodations?
382.83 Through what mechanisms do carriers make seating accommodations? ETA Editor's Note This section has no content in the original document.
-
11B-708.3 Handsets
Handset cords, if provided, shall be 29 inches (737 mm) long minimum.
-
Requirements to Remember for: Light Rail Projects
[See subsections ...]
-
Sec. 12143. Paratransit as a complement to fixed route service. [Section 223]
[See subsections ...]
-
4.28.3(3)
(3) The maximum pulse duration shall be two-tenths of one second (0.2 sec) with a maximum duty cycle of 40 percent. The pulse duration is defined as the time interval between initial...
-
Location and Spacing
Location and Spacing Rooms with an area than can be circumscribed by a circle 50 feet in radius can be covered by a single centrally located strobe of 75 cd. For very small rooms,...
-
4.28.3(5)
(5) The flash rate shall be a minimum of 1 Hz and a maximum of 3 Hz.
-
Mounting Height
Mounting Height ADAAG specifies a signal height 80 inches above the highest floor level within the space or 6 inches below the ceiling, whichever is lower. (This can be measured...
-
2.1.2.3 New York State Standards
2.1.2.3 New York State Standards Ambient electro-magnetic fields should not exceed 30 mA/meter; higher levels would preclude the installation of an IL in the particular location....
-
ADA Facility Compliance Survey & Report Options
ADA Facility Compliance Survey & Report Options Click here to view/download the pdf "ADA Facility Compliance Survey & Report Options" (20 KB) * * * * * * *
