Located throughout the standards at the relevant scoping or technical requirement, these provisions and exceptions are distinguished by references to “alterations” or “existing facilities...
Search Results "Residential Facility"
Filters
Commonly Searched Documents
-
Special Provisions for Alterations
-
11B-809.5.3 Interconnection
The same visible alarm appliances shall be permitted to provide notification of residential dwelling unit smoke detection and building fire alarm activation, and carbon monoxide detection...
-
11B-809.5.3 Interconnection
The same visible alarm appliances shall be permitted to provide notification of residential dwelling unit smoke detection, building fire alarm activation, and carbon monoxide detection....
-
10.4.1(7)
Clocks shall be placed in uniform locations throughout the facility to the maximum extent practicable....
-
Hoist HD-1900 Dual Pulley System
The expanded HOIST® HD Series offers a comprehensive solution for fitness facilities where space, budget or both are at a premium....
-
R202 Alterations and Elements Added to Existing Facilities (Section-by-Section Analysis)
R202 Alterations and Elements Added to Existing Facilities (Section-by-Section Analysis) The proposed guidelines apply to alterations and elements added to existing facilities....
-
VI. Relationship to Other Laws
Recipients of HUD funding must be aware of and comply with the accessibility requirements of all applicable laws, including Section 504, the ABA, the ADA, and the FHAct. Compliance...
-
11B-813.2.8 Turning space
Turning space complying with Section 11B-304 shall be provided within adult changing facilities....
-
§8.23 Alterations of existing housing facilities.
[See subsections ...]
-
604.3.2 Overlap
EXCEPTION: In residential dwelling units, a lavatory complying with 606 shall be permitted on the rear wall 18 inches (455 mm) minimum from the water closet centerline where the clearance...
-
Example 1: With Cooking Facilities
With Cooking Facilities An employee break room with fixed or built-in range cooking facilities shall comply with the requirements of 212 and 804 for kitchens and kitchenettes....
-
F245.2.2 Picnic Facilities with More Than Two Picnic Units
Where picnic facilities contain more than two picnic units, at least 20 percent, but not less than two, of the picnic units shall provide mobility features complying with F245.2....
-
Section 35.151(h) Medical care facilities
Section 35.151(h) Medical care facilities In the 1991 title II regulation, there was no provision addressing the dispersion of accessible sleeping rooms in medical care facilities....
-
Section 36.406(g) Medical Care Facilities
Section 36.406(g) Medical Care Facilities In the 1991 title III regulation, there was no provision addressing the dispersion of accessible sleeping rooms in medical care facilities....
-
Public Sector (Government) Facilities
An accessible route between stories is required in multi-story government facilities subject to title II of the ADA except those with no more than two stories where the inaccessible...
-
§ 35.152(a) General
This section applies to public entities that are responsible for the operation or management of adult and juvenile justice jails, detention and correctional facilities, and community correctional...
-
11B-239 MINIATURE GOLF FACILITIES
[See subsections ...]
-
11B-239 Miniature golf facilities.
[See subsections ...]
-
11B-249 Adult changing facilities
[See subsections ...]
-
11B-239 Miniature golf facilities
[See subsections ...]
-
1132A.4 Level floor or landing
1132A.4 Level floor or landing. See also Chapter 10. The floor or landing on each side of a door shall be level. Primary entry doors, required exit doors or secondary exterior doors...
-
1132A.5 Maneuvering clearances at doors
1132A.5 Maneuvering clearances at doors.
-
1133A.4 Countertops
1133A.4 Countertops. Kitchen countertops shall comply with this section and shall be provided with the following:
-
1132A.8.1 Lever-type hardware
1132A.8.1 Lever-type hardware. The lever or lever of actuated latches or locks shall be curved with a return to within ½ inch (12.7 mm) of the door to prevent catching on the...
