deadlocking, 3/4" throw Dogging Not Available Fasteners For 1-3/4" - 2-1/4" thick wood and metal door applications Sex Bolts 8x 10-24 furnished for center case and end cap Device centerline...
Search Results "Lavatory Centerline"
- TownSteel ED1100F Grade 1 Fire Rim Device
-
805 Medical Care and Long-Term Care Facilities
The Board has added clarification that toilet and bathing rooms provided as part of a patient or resident sleeping room contain at least one water closet, lavatory, and bathtub or shower...
-
4.34.4 CONSUMER INFORMATION
occupancy: (1) Notification of the alternate heights available for the kitchen counter and sink, and the existence of removable cabinets and bases, if provided, under counters, sinks, and lavatories...
-
Toilet Room Configuration
In addition, the location of the door also permitted the toilet and lavatory in many facilities to be located at right angles to each other....
-
Dimensions for Adults and Children [§102]
These provisions address access for children to: drinking fountains (§602) water closets and toilet compartments (§604) lavatories and sinks (§606) and dining...
-
11B-809.10.7.3 Reinforcement for grab bars
Where the water closet is located adjacent to lavatories, cabinets, wing walls, or privacy walls the grab bar reinforcement shall be 36 inches (914 mm) in length....
-
Clarification on Standard Roll-In Shower Compliance
At a site I’m consulting for, the architect wants to install a fold-down grab bar to help achieve clearances in the bathroom (turning radius, lavatory clearance, etc)....
-
This is a great unit but it's not "recessed", it's semi-recessed.
If you place this unit next to the accessible lavatory or other required clear space and don't allow room for the projection, it may interfere with the minimum required clear floor space...
-
11B-805.7 Built-in cabinets and work surfaces
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1. ...
- TownSteel ED1100 Grade 1 Panic Rim Device
- TownSteel ED1400 Grade 1 Mortise Panic Device
- TownSteel ED6700 Narrow Stile Concealed Vertical Panic Device
-
Birthing Room Bath Tub Accessibility
Where provided, one water closet, one lavatory, and one bathtub or shower shall comply with the applicable requirements of 11B-603 (Toilet and Bathing Rooms) through 11B-610 (Seats)....
-
1115B.3.2, Item 3
The centerline of the water closet fixture shall be18 inches (457 mm) from the side wall or partition....
-
Types of Alternative Designs
Respondents reported the following types of design alternatives: Water Closet: The water closet was moved further away from the sidewall (> 18+" from the sidewall to the centerline...
-
11B-805.7 Built-in cabinets and work surfaces
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1....
- TownSteel ED1400F Grade 1 Mortise Fire Device
-
TABLE OF CONTENTS
Lifts (Wheelchair Lifts) 4.12 Windows 4.13 Doors 4.14 Entrances 4.15 Drinking Fountains and Water Coolers 4.16 Water Closets 4.17 Toilet Stalls 4.18 Urinals 4.19 Lavatories...
-
Opening Force [§404.2.9]
so that the face edge aligns with the door frame outside edge Place gauge immediately above door operating hardware about 2½” from the latch edge of the door (approximately the centerline...
-
11B-805.7 Built-in cabinets and work surfaces
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1....
-
What barriers will it be "readily achievable" to remove?
accessible path; 11) Installing accessible door hardware; 12) Installing grab bars in toilet stalls; 13) Rearranging toilet partitions to increase maneuvering space; 14) Insulating lavatory...
-
11B-404.2.9 Door and gate opening force
At each location where push plates are provided there shall be two push plates; the centerline of one push plate shall be 7 inches (178 mm) minimum and 8 inches (203 mm) maximum above the...