The side wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall...
Search Results "Rail System"
Filters
Commonly Searched Documents
-
11B-604.5.1 Side wall
-
11B-215.5 Residential facilities
Where provided in residential dwelling units required to comply with Section 11B-809.5, fire alarms shall comply with Chapter 9, Section 907.5.2.3.3 and carbon monoxide alarms shall...
-
Cells with Communication Features: ADA Standard Section 232.2.2
Section 232.2.2 covers scoping requirements in the current ADA Standards for cells with communication features.
-
11B-232.2.2 Cells with communication features
At least 2 percent, but no fewer than one, of the total number of general holding cells and general housing cells equipped with audible emergency alarm systems and permanently installed...
-
Route and Destination Signs
The proposed rule allowed certain signs to have a 3 inch minimum height where space is limited and a 1 ½ inch height for characters on signs not essential to the use of the transit system...
-
T204 Doorways
[See subsections ...]
-
CHAPTER 7: COMMUNICATION FEATURES
[See subsections ...]
-
T302 Walking Surfaces
[See subsections ...]
-
CHAPTER 2: SCOPING REQUIREMENTS
[See subsections ...]
-
T303 Handrails, Stanchions, and Handholds
The technical requirements for handrails, stanchions, and handholds include specifications on edges, cross sections, and clearances (i.e., space between gripping surface and adjacent...
-
§ 38.107(a)
(a) If a restroom is provided for the general public, it shall be designed so as to allow a person using a wheelchair or mobility aid to enter and use such restroom as specified in...
-
§ 38.57(c)
(c) The diameter or width of the gripping surface of handrails and stanchions shall be 11/4 inches to 11/2 inches or provide an equivalent gripping surface and shall provide a...
-
§ 38.123(a)(4)
(4) Faucets and flush controls shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist. The force required to activate controls shall...
-
§ 38.125(c)(2) Ramp surface
(2) Ramp surface. The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear...
-
§ 38.125(c)(4) Ramp barriers
(4) Ramp barriers. Each side of the ramp or bridge plate shall have barriers at least 2 inches high to prevent mobility aid wheels from slipping off.
-
§ 38.93(d)(1) Requirements
(1) Requirements. Cars operating in stations with high platforms, or mini-high platforms, shall be coordinated with the boarding platform design such that the horizontal gap between...
-
§ 38.95(c)(6)(i) Requirement
(i) Requirement. When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to...
-
§ 38.83(c)(2) Ramp surface
(2) Ramp surface. The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater then 1/4 inch, shall have a clear width...
-
§ 38.113(e) Signage
(e) Signage. The International Symbol of Accessibility shall be displayed on the exterior of all doors complying with this section unless all cars and doors are accessible and are...
-
Silent Knight SpectrAlert® Advance P2WH-LF
The SpectrAlert Advance P2WH-LF is a white, two-wire, 24 volt, low frequency sounder strobe with selectable high-candela strobe settings of 135, 150, 177 and 185 cd for wall or...
-
Silent Knight SpectrAlert® Advance P2RH-LF
The SpectrAlert Advance P2RH-LF is a red, two-wire, 24 volt, low frequency sounder strobe with selectable high-candela strobe settings of 135, 150, 177 and 185 cd for wall or ceiling...
-
Honeywell AS/AH - Selectable Output Strobe & Horns
Wheelock’s patented 2-wire Series AS Audible Strobe Appliances and Series AH Audible Devices offer more features with low current draw. Strobe options for wall mount models include...
-
Honeywell SP(W) / SPC Series Indoor Speaker/Strobes
The SpectrAlert Advance Series of speakers and speaker strobes is designed to reduce ground faults. The plug-in design allows the installer to pre-wire mounting plates and dress the...
-
Honeywell SpectrAlert Advance Selectable Output Devices
Features Standard and Low Frequency models available Plug-in design with minimal intrusion into backbox Tamper-resistance construction Field-selectable candela settings...
