Turning space complying with Section 11B-304 shall be provided within adult changing facilities....
Search Results "Plumbing Facility"
-
11B-813.2.8 Turning space
-
R202 Alterations and Elements Added to Existing Facilities (Section-by-Section Analysis)
R202 Alterations and Elements Added to Existing Facilities (Section-by-Section Analysis) The proposed guidelines apply to alterations and elements added to existing facilities....
-
§ 35.152(a) General
This section applies to public entities that are responsible for the operation or management of adult and juvenile justice jails, detention and correctional facilities, and community correctional...
-
F245.2.2 Picnic Facilities with More Than Two Picnic Units
Where picnic facilities contain more than two picnic units, at least 20 percent, but not less than two, of the picnic units shall provide mobility features complying with F245.2....
-
Section 35.151(h) Medical care facilities
Section 35.151(h) Medical care facilities In the 1991 title II regulation, there was no provision addressing the dispersion of accessible sleeping rooms in medical care facilities....
-
Section 36.406(g) Medical Care Facilities
Section 36.406(g) Medical Care Facilities In the 1991 title III regulation, there was no provision addressing the dispersion of accessible sleeping rooms in medical care facilities....
-
Public Sector (Government) Facilities
An accessible route between stories is required in multi-story government facilities subject to title II of the ADA except those with no more than two stories where the inaccessible...
-
11B-239 MINIATURE GOLF FACILITIES
[See subsections ...]
-
11B-239 Miniature golf facilities.
[See subsections ...]
-
11B-249 Adult changing facilities
[See subsections ...]
-
11B-239 Miniature golf facilities
[See subsections ...]
-
1134A.7 Water closets
1134A.7 Water closets. Water closets in bathrooms or powder rooms required to be accessible shall comply with this section.
-
Specifications for Alternate Roll-in Shower Controls
Specifications for controls, faucets, and shower spray units for alternate roll-in showers are provided in section 608.5.3. In the final rule, the Board has clarified these...
-
4.21.5 Controls
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37. In shower stalls 36 in by 36 in (915 mm by 915 mm), all controls, faucets, and the shower unit...
-
Side Approach
Side Approach Side reach depth is important to consider in the design and location of sinks. Sinks located in corners may not be fully within reach and the space to the rear of...
-
4.21.5 CONTROLS
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37. In shower stalls 36 in by 36 in (915 mm by 915 mm), all controls, faucets, and the shower unit...
-
4.34.5.1 DOORS
Doors shall not swing into the clear floor space required for any fixture.
-
212 Kitchens, Kitchenettes, and Sinks
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different 212.2...
-
4.7.9.3 Height
The counter or rim of the sink shall be no more than 34 inches (865 mm) above the floor or ground. Water spouts must be 28 inches (710 mm) minimum and 36 inches (915 mm) maximum...
-
1134A.7 Water closets
Water closets in bathrooms or powder rooms required to be accessible shall comply with this section.
-
1134A.7 Water closets
Water closets in bathrooms or powder rooms required to be accessible shall comply with this section. 1. Floor space and location. The minimum floor space provided at a water...
-
201.2.1 Commercial facilities and places of public accommodation located in private residences
201.2.1 Commercial facilities and places of public accommodation located in private residences....
-
11B-232.2.1.3 Substitute cells
When alterations are made to specific cells, detention and correctional facility operators may satisfy their obligation to provide the required number of cells with mobility features by...
-
11B-232.2.1.3 Substitute cells
When alterations are made to specific cells, detention and correctional facility operators may satisfy their obligation to provide the required number of cells with mobility features by...