In alterations, full extensions of handrails shall not be required where such extensions would be hazardous due to plan configuration. ...
Search Results "Full Length Mirror"
Commonly Searched Documents
-
505.10 Handrail Extensions
-
Questionnaire
A full version of the questionnaire given to the subjects after traveling over each surface can be found in Appendix C. The questionnaire was developed by the study investigators....
-
General Nondiscrimination Requirement
Consistent with the requirements of Title III of the ADA, Blockbuster will not discriminate against any individual on the basis of disability in the full and equal enjoyment of any...
-
Detail
The models aren’t full rounds....
-
1015.3 Viewing Space
The viewing space shall be 32 inches (815 mm) maximum and 51 inches (1295 mm) minimum high above the ground and shall extend the full width of the clear ground space....
-
4.13.5 CLEAR WIDTH
EXCEPTION:Â Doors not requiring full user passage, such as shallow closets, may have the clear opening reduced to 20 in (510 mm) minimum....
-
M302.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
M301.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
11B-404.2.4 Maneuvering clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
11B-404.2.4 Maneuvering clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
-
2013 & 2016 CBC Answer
Measurement Y1 through Y3 are irrelevant because the code does not require marking to define the "length" of parking per Section 11B-502.2. Â ...
-
1134A.2 Number of complying bathrooms
Lavatories, vanities, mirrors and towel fixtures shall comply with 1134A.8. 6.     Bathrooms shall be provided with an accessible route into and through the bathroom. 7.     ...
-
1134A.2 Number of complying bathrooms
Lavatories, vanities, mirrors and towel fixtures shall comply with 1134A.8. 6. Bathrooms shall be provided with an accessible route into and through the bathroom. 7....
-
1. Sloped Surfaces
The amount of slope or grade is described as the proportion of a vertical rise to a horizontal length....
-
Selection of Methodology
complete survey questions within eight research sections: SECTION #1 Geographic, demographic, and political information (type of management agency, park location, trail name, age of trail, length...
-
11B-406.5.3 Landings
The landing clear length shall be 48 inches (1219 mm) minimum....
- AJW Architectural Products U133 56 oz. One-Piece Liquid Soap Dispenser - Surface Mounted
- AJW Architectural Products U199 Series Lever Operated, ABS Roll Towel Dispenser - Surface Mounted
- AJW Architectural Products U5814 Unidoor 1.5 Gallon Sanitary Napkin Disposal - Recessed
- AJW Architectural Products U685 Series Dual Toilet Tissue Dispenser & Sanitary Napkin Disposal - Partition Mounted
-
406.7 Islands
Each 48 inch (1220 mm) minimum by 36 inch (915 mm) minimum area shall be oriented so that the 48 inch (1220 mm) minimum length is in the direction of the running slope of the curb ramp it...
-
1003.2.2 Boarding Piers at Boat Launch Ramps
Where the total length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9145 mm) minimum, gangways shall not be required to comply with 405.2...
-
5.9 Standing Support Recommendations for M304 Diagnostic Equipment Used by Patients in a Standing Position
These standing supports may be provided in a horizontal position, vertical position, or a combination of horizontal and vertical positions, as long as the minimum length of gripping surface...