Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end 6 inches (152 mm) maximum from the end walls of the bathtub....
Search Results "Horizontal Position"
-
11B-809.10.5.2 Reinforcement for grab bars
-
Handrail Requirements
An exception permitted brackets and balusters attached to the bottom of a handrail provided they did not obstruct more than 20% of the handrail length, their horizontal projection was at...
-
11B-606.6 Adjacent side wall or partition
ETA Editor's Note The positioning requirement prescribed by CBC 11B-606.6 applies to lavatories, not to sinks....
-
11B-606.6 Adjacent side wall or partition
ETA Editor's Note The positioning requirement prescribed by CBC 11B-606.6 applies to lavatories, not to sinks....
-
12114(c)(5)(B)
Commission, if the employees of the covered entity are employed in an industry subject to such regulations, including complying with regulations (if any) that apply to employment in sensitive positions...
-
12114(c)(5)(B)
Commission, if the employees of the covered entity are employed in an industry subject to such regulations, including complying with regulations (if any) that apply to employment in sensitive positions...
-
M303 Diagnostic Equipment Used by Patients Seated in Wheelchair
M303 allows patients who use wheelchairs to position their wheelchairs at equipment typically used in a standing position such as mammography equipment, and also applies to equipment specifically...
-
Introduction
definitions should be based on how the device is defined by manufacturer as follows: Manufacturers design examination tables with primary functions of supporting patients in a prone position...
-
EXHIBIT B
EXHIBIT B The average anthropometric dimensions employed shall be: (1) average eye height for a person sitting in a wheelchair is 47.45"; (2) horizontal distance from the eye of an average...
-
§ 38.73(d)(1) Requirements
The design of level-entry vehicles shall be coordinated with the boarding platform or mini-high platform design so that the horizontal gap between a vehicle at rest and the platform shall...
-
§ 38.93(d)(1) Requirements
Cars operating in stations with high platforms, or mini-high platforms, shall be coordinated with the boarding platform design such that the horizontal gap between a car at rest and the...
-
1009.3.2 Stairway width
The clear width of 48 inches (1219 mm) between handrails is not required for stairways accessed from a refuge area in conjunction with a horizontal exit....
-
1009.6.4 Separation
Each area of refuge shall be separated from the remainder of the story by a smoke barrier complying with Section 709 or a horizontal exit complying with Section 1026....
-
1008.3.2.3 Transfer Supports
Some examples of supports include a rope loop, a loop type handle, a slot in the edge of a flat horizontal or vertical member, poles or bars, or D rings on the corner posts....
-
216.4.1 Exit Doors
An exit passageway is a horizontal exit component that is separated from the interior spaces of the building by fire-resistance-rated construction and that leads to the exit discharge or...
-
21. How should an employer handle leave for an employee covered by both the ADA and the Family and Medical Leave Act (FMLA)?
If it is an undue hardship under the ADA to hold open an employee's position during a period of leave, or an employee is no longer qualified to return to his/her original position, then...
-
11B-602.2 Clear floor space
Units shall have a clear floor or ground space complying with Section 11B-305 positioned for a forward approach and centered on the unit....
-
11B-602.2 Clear floor space
Units shall have a clear floor or ground space complying with Section 11B-305 positioned for a forward approach and centered on the unit....
-
E. Employment Opportunities For Handicapped Applicants
Recipients must provide equal employment opportunities for teaching and administrative positions to handicapped applicants who can perform the essential functions of the position in question...
-
§ 38.95(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when...
-
§ 38.83(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when...
-
§ 38.23(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position...
-
§ 38.125(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded...