resists fingerprints and water spots for a cleaner looking kitchen equipped with the Reflex™ system for smooth operation, easy movement and secure docking of the pulldown/pullout spray head...
Search Results "Head Drop Test"
- Moen Delaney with MotionSense Spot Resist Stainless One-Handle High Arc Pulldown Kitchen Faucet
- American Standard Barton Single Control Pull Out Kitchen Faucet 4145SSF
-
3. Terminology
measurement, n—a series of elevation values taken at a constant interval along a wheel track. 3.1.1.1.1 Discussion—Elevation measurements may be taken statically, as with rod and level per Test...
-
Conclusion
costs-savings, decision-makers should request much more information from the manufacturer including specific instructions for installation and maintenance along with results of laboratory tests...
-
Information That May Be Requested in Post-Offer Examinations or Inquiries
An employer may give follow-up tests or examinations where an examination indicates that further information is needed....
-
EXHIBIT A
• Beginning no later than March 31, 2015 for mobile applications and September 30, 2015 for www.peapod.com, Peapod regularly conducts automated tests of and annually enlists individuals...
-
2.5.2.1 International Electrotechnical Commission (IEC) Standards
When there is no Part 2 standard, equipment is typically tested only to the general standard (i.e., IEC 60601-1)....
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Posterior most point (head, arm, WhMD, or accessory) Used to measure Occupied Length....
- NEADS (National Education for Assistance Dog Services)
- HOGGAN Wireless Dynamometer ergoFET500 Heavy Push/Pull Force Gauge
- Inpro Corporation Endurant® Stainless Steel Folding Grab Bar
-
M302 Diagnostic Equipment Used by patients in Seated Position
Stretchers have a head & back support that keep the patient in a semi-reclined position, however the patients legs are not in a dependent position such as that when sitting in a chair...
-
2. Section-by-Section Analysis of Final Guidelines
Where no discussion of comments is provided under a section heading, no comments were received on this section....
-
Americans with Disabilities Act (ADA) of 1990 (with amendments issued through 2008)
Since this codification resulted in changes in the numbering system, we provided the section numbers of the ADA as originally enacted in brackets after the codified section numbers and headings...
-
§35.150(a)(3)
The decision that compliance would result in such alteration or burdens must be made by the head of a public entity or his or her designee after considering all resources available for use...
-
3-D Shape Digitization
The first such instrument used by the Air Force was a small low- density laser scanner which rapidly passed over the head and face and, in combination with computer graphics software, produced...
-
Requirements for Effective Communication
Only the head of the agency or his or her designee can make the determination that a particular aid or service would cause an undue burden or a fundamental change in the nature of the law...
-
§ 35.164 Duties.
The decision that compliance would result in such alteration or burdens must be made by the head of the public entity or his or her designee after considering all resources available for...
-
B. NOTIFICATION
of this Consent Decree, the County will adopt and follow the attached Notice under the Americans with Disabilities Act, Attachment A (“Notice”); distribute the Notice to all its agency heads...
-
§ 35.150(a)(3)
The decision that compliance would result in such alteration or burdens must be made by the head of a public entity or his or her designee after considering all resources available for use...
-
Issue 4: Wrong pole! …Wrong message!
However, APS can be wired to a control board in the pedestrian signal head or through the controller, so it may be necessary to move the pedestrian signal head (or to completely rewire each...
-
Boat Slips: ADA Standard Section 1003.2.1
Another design solution would be to have two 40 foot (12 m) plus continuous gangways joined together at a float, where the float (as the water level falls) will stop dropping at an elevation...
-
11B-1003.2.1 Boat slips
Another design solution would be to have two 40 foot (12 m) plus continuous gangways joined together at a float, where the float (as the water level falls) will stop dropping at an elevation...