The ADA definition focuses on a bus with an elevated passenger deck over a baggage compartment (i.e., a "Greyhound-type'' bus)....
Search Results "Compartment Depth"
Commonly Searched Documents
-
Over-the-Road Bus
-
Handpumps and Water Systems
As the depth of the well increases, so does the force necessary to draw water, so most handpumps require a force greater than 5 pounds (2.2 newtons) to operate....
-
Height and Clearances [4.19.2]
Height and Clearances [4.19.2] An apron clearance of at least 29 inches (minimum depth not specified) allows a person using a wheelchair to get as close as possible to the front of the...
-
1005.2.1.1 Dispersion
Different fishing locations may provide varying water depths, shade (at certain times of the day), vegetation, and proximity to the shoreline or bank....
-
406.8 Detectable Warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
- HEWI Polymide Pull Handles
-
11B-1005.2.1.1 Dispersion
Different fishing locations may provide varying water depths, shade (at certain times of the day), vegetation, and proximity to the shoreline or bank....
-
R406 Reach Ranges (Section-by-Section Analysis)
reach ranges differ from the 2004 ADA and ABA Accessibility Guidelines in that forward reach over an obstruction is not permitted, and side reach over an obstruction is permitted where the depth...
-
M301.4.2 Clearance Around Base
clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch (25 mm) in width for each 3 inches (75 mm) in depth...
-
M302.4.2 Clearance Around Base
clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch (25 mm) in width for each 3 inches (75 mm) in depth...
-
11B-1005.2.1.1 Dispersion
Different fishing locations may provide varying water depths, shade (at certain times of the day), vegetation, and proximity to the shoreline or bank....
-
11B-1005.2.1.1 Dispersion
Different fishing locations may provide varying water depths, shade (at certain times of the day), vegetation, and proximity to the shoreline or bank. ◼...
-
806.2.4 Toilet and Bathing Facilities
In addition, required roll-in shower compartments shall comply with 608.2.2 or 608.2.3....
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
806.2.4 Toilet and Bathing Facilities
In addition, required roll-in shower compartments shall comply with 608.2.2 or 608.2.3....
-
4.3.5.3 180-degree turn around an obstacle
In our research, we studied the impact of keeping the depth of the turning area and the entry/egress aisle width identical....
-
StaLok
StaLok arrives pre‐mixed with ¼ inch minus aggregate and is applied at a 2-inch depth on top of the base....
-
Appendix A National Trails Surface Study Participating Stabilizer Companies
Soil Type Preference Aggregate Type Specs Depth of Soil and/or Aggregate Mix Klingstone 400 Klingstone Inc. ...
-
Maximum Force
Specifically, the Board asked whether a maximum 3.5 pounds of force and a maximum 1/10 inch stroke depth provide sufficient accessibility for the use of operable parts activated by a single...
-
11B-809.12 Electrical receptacles, controls and switches
When the reach is over a kitchen work surface and base cabinet, the work surface shall be 36 inches (914 mm) maximum above the finish floor and 25 1/2 inches (650 mm) maximum in depth....
-
M302.4.2 Clearance Around Base
clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch (25 mm) in width for each 3 inches (75 mm) in depth...
-
M301.4.2 Clearance Around Base
clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch (25 mm) in width for each 3 inches (75 mm) in depth...
-
Technical Memorandum TM 2012-06 Wading Pools
to the following definition contained in the Texas Administrative Code, Title 25, Part 1, §265.182(157) based on 201.1: 265.182 (157) Wading Pool – A Class D pool that has a maximum depth...