Where armrests are provided on the seating in the immediate area, folding or retractable armrests shall be provided on the aisle side of the seat....
Search Results "Transfer Seat (Amusement)"
-
11B-802.4.1 Armrests
-
§382.87 What other requirements pertain to seating for passengers with a disability?
[See subsections ...]
-
4.26.1* GENERAL
All handrails, grab bars, and tub and shower seats required to be accessible by 4.1, 4.8, or 4.9 shall comply with 4.26....
-
Bradley Partition Mounted Seat Cover Dispenser 582
Partition Mounted Serves two compartments Satin finish stainless steel 1,000 capacity
-
Bradley Surface Mounted Seat Cover Dispenser 5831
Surface Mounted Satin finish Stainless Steel 250 Capacity BradEX
-
4.26.1* General
All handrails, grab bars, and tub and shower seats required to be accessible by 4.1, 4.8, 4.9, 4.16, 4.17, 4.20 or 4.21 shall comply with 4.26....
-
5.3.3.1 Height
The total height of the toilet seat on the riser for a pit toilet shall be between 17 inches (430 mm) and 19 inches (485 mm) above the floor or ground surface....
-
1a
a. Do all small showers, if provided in accessible guestroom/suites, measure exactly 36" wide by 36" deep as shown in Figure 35(a) below: [ADA Stds. 4.21.2] Yes __ No __ N/A __...
-
11B-1009.2.2 Seat location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (406 mm) minimum from the edge of the pool....
-
11B-1009.2.2 Seat location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (406 mm) minimum from the edge of the pool....
-
AquaTrek2 ADA Transfer System
AquaTrek2 ADA Transfer System The AquaTrek2 ADA Transfer System can be used as a primary ADA access point for Leisure Rivers, Wave Action Pools, Therapy Pools, Sand Bottom Pools, Spas...
-
11B-1008.3.2.4 Contrasting stripe
Striping complying with Section 11B-504.4.1 shall be provided at each transfer step....
-
11B-1008.3.2.4 Contrasting stripe
Striping complying with Section 11B-504.4.1 shall be provided at each transfer step....
-
a. Structural Strength
The MDE NPRM proposed to require transfer supports to be capable of resisting vertical and horizontal forces of 250 pounds at all points (proposed M305.2.2)....
-
5.3.2.2 Transfer Sides Recommendation for Imaging Equipment
5.3.2.2 Transfer Sides Recommendation for Imaging Equipment On imaging equipment, the transfer surface is oriented along the long dimension of the surface on which patients are in the...
-
11B-221.4 Designated aisle seats
At least 5 percent of the total number of aisle seats provided shall comply with Section 11B-802.4 and shall be the aisle seats located closest to accessible routes....
-
Figure 610.3.2 L-Shaped Shower Seat – Drawing from the U.S. Access Board
-
National Technology Transfer and Advancement Act of 1995
The National Technology Transfer and Advancement Act of 1995 (NTTAA) directs that, as a general matter, all Federal agencies and departments shall use technical standards that are developed...
-
National Technology Transfer and Advancement Act of 1995
The National Technology Transfer and Advancement Act of 1995 (NTTAA) directs that as a general matter, all Federal agencies and departments shall use technical standards that are developed...
-
1002.4.4.1 Width and Length
Wheelchair spaces shall provide a clear width of 30 inches (760 mm) minimum and a clear length of 48 inches (1220 mm) minimum measured to 9 inches (230 mm) minimum above the floor...
-
11B-1002.4.4 Clearances
Clearances for wheelchair spaces shall comply with Section 11B-1002.4.4. Exceptions: 1. Where provided, securement devices shall be permitted to overlap required...
-
1002.4.4 Clearances
Clearances for wheelchair spaces shall comply with 1002.4.4. EXCEPTIONS: 1. Where provided, securement devices shall be permitted to overlap required clearances. 2. Wheelchair...
-
Openings, Width and Length of Wheelchair Space
Openings, Width and Length of Wheelchair Space Openings and the width and length of wheelchair spaces need to be considered in relation to each other. Openings on rides that...
-
1002.4.4.1 Width and Length
Wheelchair spaces shall provide a clear width of 30 inches (760 mm) minimum and a clear length of 48 inches (1220 mm) minimum measured to 9 inches (230 mm) minimum above the floor...
