In addition to the requirements of 4.1 to 4.33, the design of all public areas of a library shall comply with 8, including reading and study areas, stacks, reference rooms, reserve areas...
Search Results "Patient Change Area"
-
8.1 GENERAL
-
D. Notice to the Public
Within 60 days of the effective date of this Agreement, MSHA shall maintain signs of conspicuous size and print at all MSHA admitting stations, the emergency department, and wherever a Patient’s...
-
21.1 Q. Is a dwelling unit that has a split entry foyer...required to be accessible if it is a ground floor unit in a covered multifamily dwelling?
A. Yes. Under Requirement 4, there must be an accessible route into and through the dwelling unit. This would preclude a split level foyer, unless a properly sloped ramp can be...
-
7.4.6 Tread Obstacles
Tread obstacles on trails shall not exceed 2 inches (50 mm) in height measured vertically to the highest point. Where the trail surface is paved or is elevated above the natural...
-
1007.8.3 Identification
Exterior areas for assisted rescue shall have identification as required for area of refuge that complies with Section 1007.6.5....
-
11B-228.1 General
Where provided, at least one of each type of depository, vending machine, change machine, and fuel dispenser shall comply with Section 11B-309 _|Operable Parts|_. ...
-
1008.1 General
Play areas shall comply with 1008....
-
1008.1 General
Play areas shall comply with 1008....
-
Outdoor Constructed Features in Common Use and Public Use Areas [F245.4]
Where outdoor constructed features are provided in common use and public use areas that serve picnic units with mobility features, at least 20 percent, but no less than one, of each type...
-
Voting Area
to get in to the voting area, sign in at the check-in table, and go to the voting stations or machines....
-
11B-302.1 General
Exceptions: Within animal containment areas, floor and ground surfaces shall not be required to be stable, firm, and slip resistant....
-
11B-302.1 General
Exceptions: Within animal containment areas, floor and ground surfaces shall not be required to be stable, firm, and slip resistant....
-
§ 36.304(d)(2)(iii)(H)
(H) Play areas, sections 240 and 1008; 206.2.17....
-
11B-1008.1 General
Play areas shall comply with Section 11B-1008....
-
1008.1 General
Play areas shall comply with 1008....
-
11B-1008.1 General
Play areas shall comply with Section 11B-1008....
-
11B-1008.1 General
Play areas shall comply with Section 11B-1008....
-
M305.2.1 Location
Transfer supports shall comply with M305.2.1.1 or M305.2.1.2 and shall be located 1 ½ inches (38 mm) maximum measured horizontally from the plane defined by the nearest edge of the...
-
M305.2.4 Cross Section
Transfer supports shall have a cross section complying with 305.2.4.1 or 305.2.4.2.
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed...
-
M305.2.6 Gripping Surface
Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides. The bottoms of transfer support gripping surfaces...
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The proposed rule did not provide specific requirements for the cross section of transfer supports. However, in the MDE NPRM preamble, the Access Board noted that it was considering...
-
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position. Transfer supports should be required on both sides of the transfer surface and...
-
5.4.5 Transfer Support Position Recommendation for M301 and M302
5.4.5 Transfer Support Position Recommendation for M301 and M302 Description: Transfer support position refers to the placement of the gripping surface within the minimum and...