The end result is a floor surface engineered for lasting beauty and trouble-free maintenance....
Search Results "Parking Surface"
Filters
Commonly Searched Documents
-
Non Slip Safety Solutions
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
-
3.2.1 General
Vehicle parking spaces shall comply with section 3.1....
-
Slope Meters and Levels
Corada has reviewed several models of slope meters and levels to assist accessibility surveyors in measuring slope and level changes. The following are the models that can be...
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
UltraPlay Recycled Rubber Tile Surface
Allows for individual tile replacement Superior shock absorption characteristics Provide a guaranteed critical fall height value Is a good solution for playgrounds erected on a smooth surface...
-
Winter Wonderland????
Where did the parking space go?...
-
WoodCarpet Ground Surface System: WoodCarpet Mat Installation Video
-
3.2.4 Slope
The ground surface in all camp living areas shall have a slope of no more than 1:48 (2 percent) in any direction. Exception....
-
NanoPave® 2-in-1 Joint Stabilizer and Sealer
NP-JSS is a UV resistant, VOC-free sealant that protects and helps maintain the natural beauty of most paving surfaces....
-
11B-302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3, 11B-409.4.3, 11B-410.4, 11B-810.5.3...
-
Why a smooth surface door or kickplate is important
And those nicks slice your fingers like butter when you least expect it.
-
(3) Adjustability: Transfer Surface Intermediate Heights
In the MDE NPRM there was no requirement for the transfer surface to have intermediate transfer heights....
-
Performance and the Surface Deficiency Score
In an effort to statistically analyze the frequency of identifiable deficiencies between surface types, the Surface Deficiency Score (SDS) was developed. ...
-
On existing locations when we add an EV station as van accessible how do we address taking two spaces from the facility (losing a space) and then not having the mandatory spaces remaining for the facility?
Parking ordinances are typically adopted within each city and county in California....
-
III. Results of the Study
Table 10 shows the surface materials recommended by region and surface composition....
-
11B-302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3 _|Platform to Hoistway Clearance|_,...
-
T302 Walking Surfaces
The technical requirements for walking surfaces include provisions on slip resistance, the maximum size of surface openings, and the maximum height of vertical surface discontinuities (i.e...
-
A4.5.3 Carpet
Much more needs to be done in developing both quantitative and qualitative criteria for carpeting (i.e., problems associated with texture and weave need to be studied). However,...
-
Carpet [§302.2]
Carpet [§302.2] Carpet that is thick, cushiony, or loose impairs accessibility, particularly wheelchair maneuvering. The standards specify the maximum pile height (1/2” measured...
-
14) Carpet and carpet tile
14) Carpet and carpet tile ADAAG: Same standards for carpet and carpet tile: maximum pile height of 1/2" (§4.5.3). UFAS: Carpet must have maximum pile height of 1/2". Carpet...
-
M303.2.5 Surfaces (Section-by-Section Analysis)
The MDE NPRM proposed to require diagnostic equipment used by patients seated in a wheelchair to provide a wheelchair space with a surface that does not slope more than 1:48 in any direction...
-
Acceptable SEWF Systems
Because of their reactivity, the stabilizing binders needed to be applied on site or mixed with EWF no longer than 1 h prior to placement on the ground surface....
