This video produced by the Institute for Human Centered Design represents an abbreviated study of five User/Experts with different functional conditions transferring on and off of a...
Search Results "Drinking Fountain Spout Height"
Filters
Commonly Searched Documents
-
IDeA Center: Transferring from Wheeled Mobility to MidMark's Barrier-Free Examining Table
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
Check-Out Aisles and Sales and Service Counters
Where the counter is a single-height counter, this requirement applies across the entire depth of the counter top....
-
Sec.36.403(g)(2)(v)
(v) Accessible drinking fountains; and...
-
§ 36.403(g)(2)(v)
(v) Accessible drinking fountains; and...
-
Adjustable height/gap protocol
Adjustable height/gap protocol: From the initial setup, a gap separating the device and platform was introduced with the plywood blocks of 3.5” (8.9cm) and then the height of platform was...
-
Adjustable height/gap protocol
Number of subjects that were able to attain a certain gap at a certain height under adjustable height/gap protocol Height\Gap 3.5" 7"...
-
Check Height and Location of the Pushbutton
Check Height and Location of the Pushbutton Confirm that pushbutton height and location conform to specifications and can be reached by a person in a wheelchair, from a hard surfaced level...
-
M301.2.3.1 End Transfer Surface
End transfer surfaces shall be 28 inches (710 mm) wide minimum and 17 inches (430 mm) long minimum. EXCEPTION: Transfer surfaces for imaging equipment with bores shall be...
-
M301.2.3.2 Side Transfer Surface
Side transfer surfaces shall be 28 inches (710 mm) wide minimum and 28 inches (710 mm) long minimum. EXCEPTION: Transfer surfaces for imaging equipment with bores shall be...
-
M301.2.4 Unobstructed Transfer
Each transfer surface shall provide two unobstructed sides for patient transfer. EXCEPTIONS: 1. Obstructions no more than 3 inches (75 mm) deep shall be permitted to extend beyond...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M301.4.1 or M301.4.2. EXCEPTION: Where fixed overhead patient...
-
M301.2.4 Unobstructed Transfer (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that each transfer side provide unobstructed access to the transfer surface, with an exception to permit temporary obstructions as long as...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with a patient lift and shall comply with M301.4.1 or M301.4.2.
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface. Each transfer side...
-
Wall-Mounted Objects
Overhangs that are above cane sweep height may protrude 4 inches without being hazardous....
-
§ 35.151(b)(4)(iii)(B)(4)
(4) Costs associated with relocating an inaccessible drinking fountain....
-
American Standard Monterrey 8" Widespread Faucet, Rigid/Swivel Gooseneck Spout
Pressure-Compensating rose spray provides consistent flow of 1.5 gpm throughout the entire pressure range Field-convertible rigid / swivel gooseneck spout Ceramic Disc Valves...
-
Delta Two Handle Wall-Mount Lavatory Faucet with Channel Spout T3568LF-WL
3-hole 8" center wall mount installation Rigid channel spout 7 5/8" long Metal lever handles Accommodates wall thicknesses from 1/8" to 1 1/8"...
