Each designated aisle seat shall be identified by a sign or marker. Advisory 802.4.2 Identification....
Search Results "Seating Space"
-
802.4.2 Identification
-
Wheelchair Spaces
Comments from industry noted that such a requirement would increase space requirements at wheelchair seating areas. Response....
-
M303.2.4.1 Breast Platforms
Wheelchair spaces beneath breast platforms shall comply with M303.2.4.1....
-
802.1 Wheelchair Spaces
802.1 Wheelchair Spaces. Wheelchair spaces shall comply with 802.1....
-
221.2.1.2 Luxury Boxes, Club Boxes, and Suites in Arenas, Stadiums, and Grandstands
In each luxury box, club box, and suite within arenas, stadiums, and grandstands, wheelchair spaces complying with 802.1 shall be provided in accordance with Table 221.2.1.1....
-
§ 38.27(c)
a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum character height (using an upper case “X”) of 5/8 inch, with “wide” spacing...
-
R404 Clear Spaces (Section-by-Section Analysis)
R404 Clear Spaces (Section-by-Section Analysis) Clear spaces are required at operable parts (see R403.2), including accessible pedestrian signals and pedestrian pushbuttons (see R209)...
-
11B-903.2 Clear floor or ground space
Clear floor or ground space complying with Section 11B-305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....
-
11B-903.2 Clear floor or ground space
Clear floor or ground space complying with Section 11B-305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....
-
11B-903.2 Clear floor or ground space
Clear floor or ground space complying with Section 11B-305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....
-
Common Questions (Clear Floor or Ground Space and Turning Space)
Common Questions
-
Wheelchair Turning Space [4.2.3]
T-Shaped Turns Space for 3-point turns can be provided in the space of a T. This space can be configured for approach on any segment of the T....
-
Passing Spaces [1016.4]
Passing spaces must be: A minimum space of 60 by 60 inches or The intersection of two ORARs that provide a T-shaped space that complies with section 304.3.2 of the ABA Standards...
-
Just Manufacturing Classroom Concealed Ledgemount Teardrop Handles Restricted Swing Faucet
Replaceable seats. Brass Quarter turn stem units. Chrome plated die cast teardrop handles. Equipped with water saving aerator....
-
5.8.2.3 Overall Knee and Toe Clearance
The overall knee and toe space should be increased to a minimum of 28 inches....
-
R410.10 Line Spacing
R410.10 Line Spacing. Spacing between the baselines of separate lines of characters within a message shall be 135 percent minimum and 170 percent maximum of the character height....
-
T212 Seat Belts and Shoulder Belts
[See subsections ...]
-
Passing Spaces (R302.4) (Section-by-Section Analysis)
Passing Spaces (R302.4) (Section-by-Section Analysis) Where the clear width of pedestrian access routes is less than 1.5 meters (5 feet), passing spaces must be provided at intervals...
-
M303.2.4.1.1 Depth
Wheelchair spaces shall include knee and toe clearance 25 inches (635 mm) deep minimum and 28 inches (710 mm) deep maximum....
-
M303.2.4.1.2 Height
Wheelchair spaces shall include toe clearance 9 inches (230 mm) high minimum above the floor measured to a depth of 6 inches (150 mm) maximum from the toe end of the wheelchair space....
-
5.8.2.3 Overall Knee and Toe Clearance Recommendation
5.8.2.3 Overall Knee and Toe Clearance Recommendation The Committee recommends increasing the overall knee and toe space to 28 inches minimum....
-
A4.2.4 Clear Floor or Ground Space for Wheelchairs
The space requirements in this guideline are based upon maneuvering clearances that will accommodate most wheelchairs. Fig....
-
11B-1002.4.4.3 Permitted protrusions in wheelchair spaces
Objects are permitted to protrude a distance of 6 inches (152 mm) maximum along the front of the wheelchair space, where located 9 inches (229 mm) minimum and 27 inches (686 mm) maximum...
-
11B-1002.4.4.3 Permitted protrusions in wheelchair spaces
Objects are permitted to protrude a distance of 6 inches (152 mm) maximum along the front of the wheelchair space, where located 9 inches (229 mm) minimum and 27 inches (686 mm) maximum...
