The MDE Advisory Committee recommended amending this provision to allow transfer supports to rotate in their fittings, but to require that they not rotate when they are locked into place...
Search Results "Polling Place"
Commonly Searched Documents
-
M305.2.8 Fittings (Section-by-Section Analysis)
-
M301.4 Lift Compatibility
With a short wheelbase, one leg of a floor based mobile patient lift will be placed through the base and the second leg of the lift will be placed around the base....
-
TITLE III COVERAGE
C.F.R. pt. 36, prohibit discrimination on the basis of disability in the full and equal enjoyment of the goods, services, facilities, privileges, advantages, and accommodations of any place...
-
11B-224.1 General
For ADA scoping requirements of Title III §36.406(c) Standards for New Construction and Alterations; Places of Lodging, and also Title II §35.151(f) and Title III §36.406(e) Standards for...
-
1117B.5.5, Item 4
Braille shall be placed a minimum of 3/8 inch (9.5 mm) and a maximum of 1/2 inch (12.7 mm) directly below the tactile characters; flush left or centered....
-
224.1 General
Places of lodging and housing at a place of education shall comply with the provisions applicable to transient lodging, including, but not limited to, the requirements for transient lodging...
-
UFAS vs. ADAAG Comparison - Assembly Seating
1,000. 20 plus 1 for each 100 over 1,000. 11, plus 1 add'l.space for each total seating capacity increase of 100 UFAS scoping language: 4.1.2(18)(a) If places...
-
C.2. - If EIT is acquired through another agency’s contract, which agency is responsible for Section 508 compliance?
In addition, if the servicing agency places the order on the requiring agency’s behalf, the servicing agency needs to take necessary management steps before placing the order to ensure that...
-
3.3 Equipment Barriers and Solutions
Purchase equipment with tactile displays and/or audible (sound) output Unable to locate pin and make other adjustments to equipment Place high-contrast and tactile labels...
-
11B-224.1 General
For ADA scoping requirements of Title III §36.406(c) Standards for New Construction and Alterations; Places of Lodging, and also Title II §35.151(f) and Title III §36.406(e) Standards for...
-
11B-809.10.7.3 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Where water closets are not placed adjacent to a side wall capable of accommodating a grab bar, the bathroom shall...
-
11B-224.1 General
Access Board's Note To Reader after Section 224.5 for ADA scoping requirements of Title III §36.406(c) Standards for New Construction and Alterations; Places of Lodging, and also Title II...
- Kompan, Inc. M175 - Water Lilies Spring Rider
- Pilot Rock Varmint Defiant Trash Can Cover
- Bobrick Surface-Mounted Multi-Roll Toilet Tissue Dispenser B-4288
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Color coding shall be placed immediately above the control button. Control buttons shall be located no higher than 48 inches (1219 mm) above the ground surface adjacent to the pole....
-
1. The position exists to perform the function
The only reason this position exists is to have someone who can work on any of the three shifts in place of an absent supervisor....
-
F106 Definitions
Definitions of "private building or facility" and "public building or facility" are not included because these terms are used to distinguish between places of public accommodation and commercial...
-
1016.6 Openings
Elongated openings should be placed so that the long dimension is perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....
-
707.1 General
Place accessible gates and fare vending machines in close proximity to other accessible elements when feasible so the facility is easier to use....
-
DEFINITION: MOBILITY DEVICES
FIND IT IN THE REGULATIONS State and Local Governments: §35.104 definition and §35.137 mobility devices Places of Public Accommodation: §36.104 definition and §36.311 mobility devices...
-
M302.3.3 Head and Back Support (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed to place the requirements for head and back support for diagnostic equipment used by patients in the seated position in M302....
-
M301.3.3 Head and Back Support (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed to place the requirements for head and back support for diagnostic equipment used by patients in the supine, prone, or side-lying position in M301...
-
707.1 General
Place accessible gates and fare vending machines in close proximity to other accessible elements when feasible so the facility is easier to use....