A 30 inch (760 mm) wide minimum by 60 inch (1525 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
Search Results "End of Row Compartment"
Filters
Commonly Searched Documents
-
608.2.2.1 Clearance
-
608.2.2.1 Clearance
A 30 inch (760 mm) wide minimum by 60 inch (1525 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
-
Safety
For example, if an FAA safety rule provides that only persons who can perform certain functions can sit in an exit row, then you can request that an individual unable to perform those functions...
-
1. Common Problems and Solutions in Website Accessibility
Resources providing more detailed information on accessible website design are provided at the end of this Chapter....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
M301.2.3 Size (Section-by-Section Analysis)
discussed in Section IV.B.1.c (Significant Changes – Transfer Surface Size), in the final rule the Access Board has revised this provision to account for the two types of transfer surfaces (end...
-
A.2.ii. - Should EIT be compatible with assistive technology?
These products, such as information kiosks, copiers, or other similar products that do not permit a user to install or connect assistive technology, must be designed so that an end user...
-
M301.2.3 Transfer Surface Transfer Sides
The option to transfer will be required only on one long side of the patient scanning/imaging table and not at the “foot” or “head” end of such surfaces....
-
2010 ADA Standards
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
ADA Title II Technical Assistance Manual 1994 Supplement
These supplements are to be inserted, as appropriate, at the end of each chapter of the Manual....
-
Wheelchairs
storage in the cabin of wheelchairs or components of wheelchairs, including folding, collapsible, or breakdown battery-powered wheelchairs [Sec. 382.41(e)] as follows: • In overhead compartments...
-
F203 General Exceptions
For example, UFAS Section 4.17 contains provisions for wheelchair accessible toilet compartments, but does not contain provisions for ambulatory accessible toilet compartments....
-
§ 37.91(d)
(d) Unless not practicable, a person providing intercity rail transportation shall place an accessible car adjacent to the end of a single level dining car through which an individual who...
-
Tork Elevation® Matic® Hand Towel Roll Dispenser with Intuition® Sensor, Black
An adjustable towel length of 8 inches to 24 inches, and a stub roll compartment combine to deliver more precise control of consumption are a few of the features available....
-
12 [§ 4.7.9]
12 [§ 4.7.9] When a curb ramp is located at a marked crossing, the area where the ramp run ends must be contained within the marked crossing....
-
4.20.3 Seat
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
4.20.3 SEAT
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
5.4.4 Transfer Support Distance from Transfer Surface Recommendations for M301 and M302
that is opposite the transfer side (see M301.2.3 and M302.2.3) similar to the provisions in the 2004 ADA and ABA Accessibility Guidelines for grab bars provided at bathtubs and shower compartments...
-
If Service Animal Cannot be Accommodated at Assigned Seat
Switching seats in the same class of service must be explored as an alternative before requiring that the service animal travel in the cargo compartment. [Sec. 382.37(c)]...
