Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings....
Search Results "Assurances from Contractors"
Filters
Commonly Searched Documents
-
11B-502.1 General
-
4. Faucet Controls
Are the faucet controls and shower wand positioned on the wall along the side of the shower seat so they are operable from the folding shower seat or from the shower wheelchair?...
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers....
-
404.2.8.1 Door Closers and Gate Closers
Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
-
2. VOLUNTARY SUBMITTAL:
This interpretation does not preclude a design professional or school district from choosing to submit plans and specifications with the appropriate fee to DSA for review, even when the...
-
4.10.4(3)
(3) Signals shall be visible from the vicinity of the hall call button (see Fig. 20)....
-
407.3.4 Door and Signal Timing
The minimum acceptable time from notification that a car is answering a call or notification of the car assigned at the means for the entry of destination information until the doors of...
-
407.3.4 Door and Signal Timing
The minimum acceptable time from notification that a car is answering a call or notification of the car assigned at the means for the entry of destination information until the doors of...
-
604.8.1.2 Doors
Doors shall be located in the front partition or in the side wall or partition farthest from the water closet....
-
36 Inch Wide Stalls
This stall is specifically designed for people who have difficulty walking or standing from a seated position....
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
11B-407.3.4 Door and signal timing
The minimum acceptable time from notification that a car is answering a call until the doors of that car start to close shall be calculated from the following equation: T = D/(1.5 ft/...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
NFPA
a stationary or fixed cooking appliance shall be listed for resistance to common nuisance sources from cooking. 6) Installation near bathrooms....
-
Confidentiality
Confidentiality Information from all medical examinations and inquiries must be kept apart from general personnel files as a separate, confidential medical record, available only under...
-
2. Beds
Beds: Providing beds at an appropriate height, generally from 17 to 19 inches, facilitates transfers to and from wheelchairs....
-
Standard Roll-In Type Shower Compartments: ADA Standard Section 608.3.2
Section 608.3.2 covers the current ADA Standards for grab bars in standard roll-in type shower compartments.
-
1009.6.4 Separation
Each area of refuge shall be separated from the remainder of the story by a smoke barrier complying with Section 709 or a horizontal exit complying with Section 1026....
-
1009.3.2 Stairway width
The clear width of 48 inches (1219 mm) between handrails is not required for stairways accessed from a refuge area in conjunction with a horizontal exit....
-
Quadraplegic Transfer
This video is a demonstration of how to transfer from a wheelchair to a bed by a C6 quadriplegic man....
-
S.R. Smith MultiLift Pool Lift Video 1: Installation, Operation, and Maintenance
This video shows how to install and operate a multiLift pool lift from S.R.Smith....
-
Conventions used in this Pocket Guide
Black Text, Italicized Used by CBC to identify departures from IBC and/or 2010 ADAS....
-
11B-404.2.4.1 Swinging doors and gates
Approach direction Door or gate side Perpendicular to doorway Parallel to doorway (beyond latch side unless noted) From...
-
11B-404.2.4.1 Swinging doors and gates
Approach direction Door or gate side Perpendicular to doorway Parallel to doorway (beyond latch side unless noted) From...
